Laserfiche WebLink
*,,SANTA <br />ANAJIiiffi <br />Planning & Euilding Agency <br />Buildlng Safety Division <br />20 Clvic Center Plaza <br />P.O. Box'1988 (M-19) <br />Sanla Ana, CA 92702 <br />(7r4) 647-s800 <br />www.santa-ana,o19 <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />soL,01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached STNGLE FAMtLy RESTDENCES Onty <br />lnstructions: The licensed contractor of record shall complete all sections, answer the len questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets ot plans, of <br />minimum 1'1" x 17" size. lf answerinq NO to anv of the questions. Dlan ch eck shall be req uired. <br />PrqeaAuaress: 1725 W TTH ST, SANTAANA, CA 92703 <br />conlractor company Name: -XOUTHWEST <br />SUNm <br />Contractor a,""n"" rr'nO"r, <br />YES NO1 6tr <br />2 Eltr <br />3. Eltr <br />81 tr <br />gtr <br />Etr <br />Etr <br />4 <br />5 <br />6 <br />7 <br />8 <br />I <br />Etr <br />&tr <br />Are the following applicablo to the proposed project? <br />Will the PV system layoul provide lhe required three-foot wide clear access pathways <br />per Seclion 605.1 'l of the Catifomia Fire Code, and is this shown on the roof plan? <br />Will ths PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV anay be flush mounted to the existing roof so that the ptane of the <br />modules (panels) are parallel lo the plane of ths roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modul€s do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system b€ installed with a space of 2" minimum to 10" maximum b€tween <br />the underside of modules and lhe surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed wilh a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16'lag screws be installed with a minimum of Z-1tZ inch <br />embedmenl into roof rafters (with pre-drilled holes) and is this minimum emb€dment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specmc site plan, pV layout, <br />anchorage spacing, anchorage details and manufactureds pV support information.) <br />10 Etr <br />I certify under penalty of periury under the laws of the State ol California <br />pdnl x3rns. TRANG CONG PHAM <br />Phone Number: 714 582 3909 <br />Signature <br />Date: <br />Emait Address: pERMIT@SOUTHWESTSUNSOLAR.COM <br />at above is true: <br />Rev:8/1712015