Laserfiche WebLink
*,,SANTA <br />NA <br />tlr\l\c <br />&ilut\c <br />mm <br />Planning & Bullding Agency <br />Building Srtsty Divl3lon <br />20 Clvlc Conter Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(71'l) 647-s800 <br />www.santa€na.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />- <br />sol-o1 cBc 2013 <br />So18r Photovoltalc (PV) Checklist for Detached STNGLE FAMILY RESTDENCES Onty <br />lnstructlons: The licensed contractor of record shall complete all sectlons, answer the ten questions and <br />sign the certilication section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 'l 7" <br />ProJect Address: <br />size. lf answerinq NO anv of the ouestions. olan check shall be required <br />2049 W HARVARD ST, SANTA ANA, CA 92704 <br />Contractor Company Name:SOUTHWEST SUN SOLAR, INC <br />contracrorLlcenseNumber: 1004667 <br />YES NO Are the followlng appllcablo to lhe proposed prolect? <br />Will the PV system layout provide the rsquired thre6-foot wide clsar access pathways <br />per Section 605.1 1 of the Califomia Fire Code, and is this shown on the roof ptan? <br />Will the PV system be installed on a roof having only one rooling layer with no <br />ovedays? <br />Will the PV anay be flush mounted to the existing roof so thal the ptane of the <br />modulss (panels) are parallel to ths plane of the roof? <br />Will the PV system welgh maximum 4 pounds per square feet or less? <br />Will th6 PV system be inslalled whsre the modulos do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10' maximum between <br />the underside of modules and the surface of the roof? <br />Will ths PV system be installed without using any ballast syslem or counter-weight <br />system? <br />Wll the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16'lag screws be installsd with a minimum of 2-112 inch <br />embedment into roof rafiers (with pre{rilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stampsd and signed by a Califgrnia <br />tr tr <br />Etr <br />Etr <br />tstr <br />Etr <br />Btr <br />atr7 <br />8 atr <br />9. Etr <br />10 Etr <br />licensed professional engineer? (including project specific site plan, pV I <br />anchorage spacing, anchorage details and manufaclurer's PV supp o orm ation.) <br />I cerlify under penalty of perjury under lhe laws o, lhe State of California <br />prinr Name: TRANG CONG PHAM <br />phone Number: 714 582 3909 <br />Signature <br />Date: <br />Email Address: <br />Rev:8/1712015 <br />PERMIT@SOUTHWESTSUNSOLAR.COM <br />above is true: <br />1. <br />2. <br />3. <br />4. <br />5. <br />6.