Laserfiche WebLink
.-,,SANTA <br />NA,ffi <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647.5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-o1 cBc 2013 <br />Solar Photovoltaic (PV) checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />stgn the certtflcatton section below A copy of this form shall be attached to each of TWO sets of plans, of <br />mrnrmum 11 x 17' size lf answerinq NO to anv of the q uestions, plan check shall be required <br />Project Address:2223 W St Anne Pl Santa Ana CA 92704 <br />Contractor Company Name:ParagonSun <br />Contractor License Number. 1025115 C46 <br />YES NO Are the following applicable to the proposed proiect? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1 1 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays2 <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof2 <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves. gabled ends ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to l0" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counterweight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />EI <br />2 trtr <br />Etr <br />trtr <br />trtr <br />trtr <br />Etr <br />3 <br />4 <br />5 <br />6 <br />7 <br />8 Etr <br />9 trtr <br />10 tr <br />under the laws of the State of California that the above is true: <br />pnnt Name Erik Larsen Signature <br />Phone Number 949-529-4401 <br />Emait Address lnfo@psun.us <br />Rev 8/17/2015 <br />g^s 101212017 <br />tr <br />I certify under penalty of perjury