Laserfiche WebLink
*-SANTA <br />NAqMI <br />Planning & Building Agency <br />Building Satety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-'t9) <br />Santa Ana, CA 92702 <br />(7111U7-5800 <br />wlYlY,sa nta -a na .o rg <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol,01 cBC 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complele all seclions, answer the ten questions and <br />sign the certifoation section below. A copy of this form shall be attached to each of Tl /lc sets of plans, of <br />minimum 11" x 17" size. lf answerinq NO to anv of the auestions, Dlan check shall be required. <br />Project Address:AC€-So-h1o= <br />Contractor Company Name: Complete Solar Soluttons of Caltfornia, lnc. <br />Contractor License Number: 961988 <br />)l I!\r <br />3 <br />YES NOdo <br />dn <br />ilo <br />dodo <br />Are the following applicable to the proposed project? <br />!\illl the PV system layout provide the required lhree-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV syslem be rnstalled on a roo, having only one roofrng layer wilh no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Wll the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Wll the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />VVill the PV system be installed withoul using any ballasl system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feel <br />and rs lhis rnaximum honzontal spacing shown on the plans? <br />Willthe minimum 5/16' lag screws be installed w1h a minimum ot 2-112 inch <br />embedrnent into roof rafters (with pre-drilled holes) and is this minimum embedrnent <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed professbnal engineer? (including proJect speclfic site plan, PV layout, <br />anchorage spacing. anchorage details and manufaclurer's PV support information ) <br />4 <br />5 <br />6 <br />7 <br />I <br />9 <br />do <br />do <br />do <br />du <br />10 d tr <br />I certify undor penalty of perjury under the laws of the State of California that the above is true <br />print Name: Evan FranCiS Signature <br />Date: \PhoneNumber: 650-610-1777 <br />Ematl Address: DermltsG)comDletesolar.com <br />Rev 81712015 <br />Ftatzr,a- <br />'2\ <br />-{