Laserfiche WebLink
*,SANTA <br />N4""il,ffi <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M.19) <br />Santa Ana, CA92702 <br />(714) 647-s800 <br />www.santa-ana.org <br />sol_01 cBc 2013 <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Onty <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11' x 17' size. lf answ erinq NO to anv of the o uestions, olan check shall be req uired <br />Co,k}. <br />Project Address <br />Contractor Company Name: <br />Contractor License Number: <br />C <br />A <br />2 <br />3 <br />4 <br />6 <br />7 <br />qqq lle, <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />--Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2' minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum ot 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, pV layout, <br />anchorage spacing, anchorage details and manufacturer's pV support information.) <br />I certify under penalty of perjury under the laws of the State of Cal fornia th <br />['hi.,v-.,..r,-, (l <br />YES -}lO{a <br />da <br />{a <br />{a <br />daffi <br />{a <br />da <br />8 <br />I <br />10 <br />Print Name Signatu <br />Date:Phone Number <br />Email Address:t <br />Rev 11/19i 2015 <br />a(})- <br />.- rA <br />is <br />I