Laserfiche WebLink
-,-SANIA <br />NA <br />Itr\w <br />TB[IDIIC <br />tfiICI <br />Planning & Building Agency <br />Building Safety Oivision <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />SOL 01 CBC 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certiflcation section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerinq NO to anv of the questions, plan check shall be required. <br />Project Address:lolo t ,+tr ,\,*t- <br />Contractor Company Name: <br />Contractor License Number <br />Sunr <br />1 <br />2 <br />YES NOEtr <br />trtr <br />trtr <br />Etrtrtr <br />6a <br />Etr <br />Eltr <br />trtr <br />trtr <br />,7f,o <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1 1 of the California Fire Code, and is this shown on the roof plan? <br />Wll the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Wll the PV system be installed with a space of 2" minimum to '10" maximum between <br />the underside of modules and the surface of the roof? <br />Wll the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Wll the minimum 5/16" lag screws be installed with a minimum ot 2-112 inch <br />embedment into roof rafters (with pre-drllled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the slructural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />3 <br />4 <br />5 <br />6 <br />7 <br />8 <br />I <br />10 <br />I certify u nderJEnalty <br />Lz- <br />Print Name: )' C <br />Phone Number: 1W. L{b0'31 <3 <br />of perjury under the laws of the State of Califo <br />MA t+^rro,Signature <br />Date: <br />Re.r': 8h712015 <br />o{1<?t Q*9Onr,t <br />B,( .r( <br />above is true: <br />Email Address