Laserfiche WebLink
*-SNTA <br />NAJffi <br />Planning E Building Agency <br />Building Satety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-s800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol.01 cBc 201? <br />solar Photovoltaic (PV) checklist for Detached StNGLE FAMTLY RESIDENCES Onty <br />lnstructions: The licensed contractor ot record shall complete all sections, answer the ten questlons and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x '17" size. lf answerino NO to anv of lhe ou . plan check shall be reouired. <br />Project Address:1526 W 121N ST, SANTA ANA, CA 92703 <br />Conlractor Company Name:SOUTHWEST SUN SOLAR, INC <br />conlractor Lic€nse Number: 1004667 <br />Are the follovring applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof ptan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum betv/een <br />the underside of modules and the surface of the roof? <br />Will the PV system be inslalled without using any ballast system or counter-weight <br />system? <br />Wilt the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizonlal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-dilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specific site an, PV layout, <br />anchorage spacing, anchorage details and manufactureis PV upport n.) <br />I certify under penalty of perjury under the laws of the State of California t at bove is true <br />pdn1x2ms. TRANG CONG PHAM <br />phone Number: 714 582 3909 <br />Emai I AddTESS: PERN/IT@SOUTHWESTSUNSOLAR,COM <br />3 <br />YES NO <br />1. trtr <br />2 EE <br />6. tsE <br />7. 8tr <br />8. Etr <br />e. trtr <br />10. EE <br />Etr <br />Etr <br />Etr <br />4 <br />5 <br />Signature <br />Date: <br />Rey: A117/2415 <br />e <br />t8