Laserfiche WebLink
*,'SANTA <br />NA-tffi <br />Planning & Building Agency <br />Building Sarety Division <br />20 Clvic Cent€r Plaza <br />P.O. Box'1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />soL-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Oetached STNGLE FAMtLy RESTDENCES Onty <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall b6 attached to Bach of TWO sets of plans, of <br />minimum 11" x 17" size. lf answeri NO to anv of the oues ons. Dlan check shall req u ired. <br />ProjectAaarees: 760 W. ASTER PL, SANTAANA, CA 92706 <br />contractor company Name: SOUTHW <br />Contractor Llcens" nu;n*r, <br />YES NO Are the follovylng applicable to the pioposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605. 11 of the Califomia Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounled to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of ths roop <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modulos do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system bo installed with a space of 2" minimum to lO" maximum between <br />the undeBide of modules and the surface of the roof? <br />Will lhe PV system be installed without using any ballast system or counter-weight <br />system? <br />Will lhe anchors be installed with a maximum horizontal anchor spacing of 6 feel <br />and is this maximum horizontal spacing shown on ths plans? <br />Will the minimum 5/16" lag screws be installed with a minlmum of 2-112 inch <br />embedment into roof raflers (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, pV layout, <br />anchorage spacing, anchorage datails and manufactura/s pV support information.) <br />E tr <br />2 Etr <br />EXtr <br />Ertr <br />Ettr <br />trtr <br />&tr <br />3 <br />4 <br />5 <br />6 <br />7 <br />8 Etr <br />I Ettr <br />10 Etr <br />I certify under penalty ot periury under the laws ot the State of Calitornia <br />pdnl x6mg. TRANG CONG PHAM <br />phone Number: 714 582 3909 <br />Signature <br />Date: <br />Emait Address: PERMIT@SOUTHWESTSUNSOLAR.COM <br />Rev:8/1712015 <br />the ova is true: