Laserfiche WebLink
.-,,SANIA <br />NAJhffi <br />Planning & Building Agency <br />Building Safety Oivision <br />20 Civic Center Plaza <br />P.O. Box'1988 (M-19) <br />Santa Ana, CA927O2 <br />(7r4) 647-s800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cac 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerinq NO to anv of the questions, plan check shall be required. <br />Project Address:oh) <br />Contractor Company Name: <br />Contractor License Number: <br />4 <br />5 <br />2 <br />3 <br />6 <br />7 <br />8 <br />9 <br />Ttsot o <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.'1 1 of the Califomia Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />lcertify under penalty of perjury under the laws of the State of California that the a <br />print Name: C otaerd eq faeO <br />Eo <br />Etr <br />YEF NO <br />Nu <br />Etr <br />Ku <br />Es <br />Eu <br />EU <br />Elu <br />Ftr10 <br />Phone Number 1t.t- 61 l,t- zttl Signature <br />Date: <br />Emait Address: Cou2-11)Ev 6o,o Q ,Cnt-*Z <br />Rev: 11i 19/2015 <br />-3 O. Corn <br />is true <br />1