Laserfiche WebLink
*-SANTA <br />NAJiffii <br />Planning & Bullding Agency <br />Building Sdoty Divislon <br />20 Clvlc Csnter Plaza <br />P.O. Box 1988 (M.19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />wtvw,santa.ana.olg <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />--sol-01 csc 2013 <br />Solar Pholovoltaic (PV) Checktist for Detached STNGLE FAMtLy RESTDENCES Onty <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to sach of rwo sets of plans, of <br />minimum 1 1" x 17" size. lf answerin q NO to anv of the questions. olan check shall be required. <br />Project Address: 3001 W CUBBON ST, SANTA ANA, CA92704 <br />Contractor Company Name: <br />Conlractor License Number <br />SOUTHWEST SUN SOLAR, INC <br />1004667 <br />YES NO <br />1. 6El <br />2. EID <br />3. Etr <br />10. <br />81 tr <br />atr <br />gtr <br />Etr <br />Etr <br />Rev: 8/'1712015 <br />Are th6 following applicable to the proposod project? <br />Will the PV system layout provide lhe required three-fool wide clear access pathways <br />per Section 605.1 1 of the Catifomia Fire Code, and is this shown on the roof ptan? <br />Will ths PV system be installed on a roof having only one rooring layer with no <br />ovedays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of ths roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where lhs modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will ths PV system be installed with a space of 2" minimum to tO" maximum between <br />the undeBide of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />sYstem? <br />Will the anchors be installed with a maximum horizontal anchor spacing ot 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16'lag screws be installed with a minimum of 2-1l2 inch <br />embedment into roof rafters (with pre-drill€d holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, pV layout, <br />anchorage spacing, anchorage details and manufaclure/s pV supporl information.) <br />I cerlify under penalty of periury under the laws of the State of Cal above is true: <br />4. <br />5. <br />o. <br />7 <br />8 <br />Etr <br />81 tr <br />p n111sms. TRANG CONG PHAM <br />Phone Number: 714 592 3g0g <br />Signature <br />Date: <br />Emait Address: PERMIT@SOUTHWESTSUNSOLAR.COM <br />9. <br />,,1