Laserfiche WebLink
,-,,SANTA <br />NA <br />Itr\$0 <br />tBut0Nc <br />$M <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-s800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the ce(iflcation section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11"x 17"size. lf answerinq NO to any of the questions, plan check s hall be required. <br />P roj ect Address: Z€c>- //' F Zet'rc.tr Sr Sr+r z)\t'JA <br />Contractor Company Name: <br />Contractor License Number: <br />7Et, c, €N ee2=-, <br />?gs r-t,'7 <br />YES NO <br />1 ,Eltr <br />, PEI <br />3>9tr <br />4 Etr <br />5 -Eltr <br />6 -Eltr <br />z -El-tr <br />I -wa <br />e -.ErE <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1'1 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />ovedays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum ol 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorag e details and manufa S p information.) <br />I certify under penalty of perjury under the laws of the Stat tif or true: <br />Print Name <br />1o_9tr <br />Phone Number Cz-u\zot -B\5"o <br />Emeil Address u <br />Rev 11/19/2015 <br />Signature <br />Date:? <br />e l.)E?Q-o. (D <br />ove I <br />7