Laserfiche WebLink
,--SANTA <br />NA <br />PLr\]t\C <br />esutDt\c <br />.{ct\fl <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Cenler Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA92702 <br />(714) 647-s800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />soL-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILy RESTDENCES Onty <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certiflcation section below. A copy of this form shall be attached to each of TWO s ets of plans, of <br />minimum 11" x 17" size. lf answerin NO to anv of the o uestions. olan chec k shall be required. <br />Project Address LL1'1 €4 <br />Contractor Company Name: <br />Contractor License Number: <br />YES NO1 Eltr <br />, (tr <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will lhe PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-jtz inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages ofthe plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, pV layout, <br />anchorage spacing, anchorage details and manufacturer's pV support information.) <br />3 qtr <br />9tr <br />rytr <br />do <br />4 <br />5 <br />6 <br />7 qtr <br />trtr <br />du <br />8 <br />9 <br />10 &tr <br />I certify under p7alty of per,uryl,fnd <br />Print Name: l*lrO,A .,/1LU <br />er the laws of the State of California that the above is true <br />Phone Number Date: 6' <br />Email Address <br />Rev: 11/19/2015 <br />'(st -l <br />/ln <br />\o\1)\5X <br />/m vr> \ <br />Signature: