Laserfiche WebLink
,-,,SANTA <br />NA,HH <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647.5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTA!C <br />CHECKLIST <br />sol-o1 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. llanswerinq NO to any ofthe questions, plan check shall be required. <br />Proj ect Address: I 2 i)G4,C. I <br />Contractor Company Name: <br />Contractor License Number: <br />2 a,, ,'L''ttish *2 rlt <br />YES,/NO1da <br />2da <br />3da <br />^do'dtru4a <br />,4a <br />oo o () <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1'l of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane ofthe <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum ot 2-112 inch <br />embedment into roof rafters (with pre{rilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />8 D <br />Co9 <br />10.d tr <br />e State of California that the above is true: <br />Signature <br />Phone Number: ?5q ?Ol',, I3 Date <br />Email Address: 1 r pSa t ad ?acSc/dt fialtittr)ft a' t'Cttt(',t7. C tJ-v4 <br />I certify under penalty of peqiury under the laws of th <br />Print Name: -fa'l'a /t 5r5 <br />Rev: 11/19/2015