Laserfiche WebLink
fiil*SNTA <br />NA <br />ILI\INC <br />&IIIDNC <br />ict\tl <br />Plann ing & Building Agency <br />Building Safety Oivision <br />20 Civic Center Plaza <br />P.O. Box 1988 (M.19) <br />Santa Ana, CA92702 <br />(7r4) 647-s800 <br />www.santa-ana.org <br />soL{1 cBC 2013 <br />Solar Photovoltaic (PV) Checklist for Detached STNGLE FAMtLy RESTDENCES Onty <br />lnslructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerin NO to anv of the oues tions. olan check shall be required. <br />Project Address:L72t wooA 9t <br />RESIDENTIAL <br />PHOTOVOLTA!C <br />CHECKLIST <br />N r-i <br />Contractor Company Name: <br />Contractor License Number:r114 1qv <br />DVAWl YL+ S ( <br />1 <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1 1 of the California Fire Code, and is this shown on the roof plan? <br />Wll the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to'10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed withoul using any ballast system or counter-weight <br />system? <br />Will lhe anchors be anstalled with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of Z-112inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, pV layout, <br />anchorage spacing, anchorage details and manufacturer's pV support information.) <br />I certify under penalty of perjury under the laws of the State of Catifornia that th ts <br />Print Name Signature <br />Date: <br />YES NOEu <br />Fu <br />$u <br />2 <br />3 <br />4 <br />5 <br />EtrFtr <br />6 <br />7 <br />8 <br />9 <br />Eo <br />Ftrpu <br />Ftr <br />pu10 <br />Qt.,2-\ q4z- tL10Phone Number <br />Email Address:l/rn <br />Rev: 11/19/2015