Laserfiche WebLink
WEEB COMPATIBILITY <br />The WEEB family of products can be used to bond anodized aluminum, galvanized steel, steel <br />and other electrically conductive metal structures. All installations shall be in accordance with <br />NEC requirements in the USA and with CSA C22.1 in Canada. The WEEBs are for use with <br />modules that have a maximum fuse rating of less than 25A. <br />WEEB-OCR on Boxed Module Frames: <br />Certain module frames do not have enough structural strength to withstand the force required to <br />embed a WEEB. These frames will deform and therefore not allow sufficient penetration of the <br />WEEB teeth. The general requirements for minimum module frame thickness of "boxed" type <br />module frames are illustrated below. For more information regarding module compatibility, <br />please see the technical documents section of our website. <br />/ i 1-r i-1 -1-1 1 \ <br />1 , :LL -1.J :, 1 <br />-9 (OK <br />NO LESS THAN 3.00 mm <br />NO GREATER THAN 8.5 mm 11- <br />NO THINNER-- THAN 1.5 mm <br />\-4 <br />Note: <br />Inspect each module frame used with a WEEB to ensure that the bottom mounting face of <br />the frame is flat, and that there are no hindrances to embedding WEEB teeth. Do not use a <br />module with a frame that prevents the WEEB teeth from embedding fully. <br />1 1 Ill /2 11 Document Number 104-0404-000095-000