Laserfiche WebLink
AC I MP <br />---- <br />SA <br />N <br />T <br />A <br /> <br />A <br />N <br />A <br /> <br />, <br /> <br />C <br />A <br /> <br />9 <br />2 <br />7 <br />0 <br />3 <br /> <br /> <br />20 <br />0 <br />8 <br /> <br />W <br />E <br />S <br />T <br /> <br />1 <br />0 <br />T <br />H <br /> <br />S <br />T <br />R <br />E <br />E <br />T <br />. <br />E3 <br />SHEET NUMBER: <br />DRAWN BY: <br />DATE:7/26/22 <br /> I <br />G <br />N <br />A <br />C <br />I <br />O <br /> <br />P <br />L <br />A <br />S <br />C <br />E <br />N <br />C <br />I <br />A <br />PR <br />O <br />J <br />E <br />C <br />T <br />: <br />Am <br />e <br />r <br />i <br />c <br />a <br />n <br /> <br />A <br />r <br />r <br />a <br />y <br /> <br />S <br />o <br />l <br />a <br />r <br /> 2 <br />0 <br />2 <br />1 <br /> <br />L <br />a <br />s <br /> <br />P <br />o <br />s <br />i <br />t <br />a <br />s <br /> <br />C <br />o <br />u <br />r <br />t <br /> # <br />1 <br />2 <br />9 <br /> <br />L <br />i <br />v <br />e <br />r <br />m <br />o <br />r <br />e <br /> <br />C <br />A <br /> <br />9 <br />4 <br />5 <br />5 <br />1 <br />84 <br />4 <br /> <br />3 <br />4 <br /> <br />S <br />O <br />L <br />A <br />R <br />Li <br />c <br /># <br />9 <br />9 <br />3 <br />4 <br />6 <br />7 <br /> <br />C <br />- <br />1 <br />0 <br /> <br />& <br /> <br />C <br />3 <br />9 <br />EXISTING HOUSE <br />SCALE: 3/32" = 1'-0" <br />PROPERTY PLAN <br />2008 WEST 10TH STREET <br />DRIVE WAY <br />PROPERTY LINE <br />(E) MAIN SERVICE PANEL <br />CONDUIT TO BE RUN ON CONDUIT <br />BLOCKS MIN. 1" ABOVE ROOF SURFACE <br />AND UNDER EAVES; CONDUIT TO BE <br />PAINTED TO MATCH EXTERIOR/EXISTING <br />BACKGROUND COLOR OF ITS LOCATION; <br />CONDUIT TO BE LABELED AT MAX 10' <br />INTERVALS. <br />CONDUIT RUN(S) AND JUNCTION BOX(S) <br />LOCATIONS MAY CHANGE DUE TO FIELD <br />CONDITIONS. CONDUIT TO BE <br />INSTALLED PER CRC R331.3 <br />Handled AC disconnect is required and "must" be <br />located within 8 feet of main service panel.No part of <br />the structure can be over 18" in height from the roof <br />without an Professional Engineer's stamp. No structure <br />may increase the height of the building by 10% of it's <br />original height. <br />FIRE SETBACKS REQUIRED: to the ridge on all sides <br />of each roof slope where panels/modules are located, <br />Fire department does not count the gable eaves as <br />part of the 3' fire pathway. 3' pathway must be <br />measured from the exterior bearing wall (applies FOR <br />2:12 ROOFS <br />NOTE: TO PROTECT EMT CONDUIT FROM <br />WEATHER CORROSION USE Paints approved for the <br />purpose. Zinc-rich paints or acrylic, urethane or <br />weather stable epoxy-based resins are frequently used. <br />Oil-based or alkyd paints should not be used. Surface <br />preparation is important for proper adherence. For best <br />results, the conduit / EMT should be washed, rinsed <br />and dried. It should not be abraded, scratched or <br />blasted since these processes could compromise the <br />protective zinc layer. A compatible paint primer or two <br />coats of paint adds protection <br />3' FIRE SETBACK ON VERY WELL <br />STRUCTURED AREA .WITH NO OVER HANG <br />(27) (N)PANASONIC EVP380 INSTALLED <br />FLUSHED ON ROOF SURFACE WITH EXISTING <br />TILT 24° AND 180° AZ & 270° AZ AND 90° AZ <br />508.41 FT² OVER SINGLE STORY HOUSE WITH <br />SHINGLE ROOF . <br />ROOF AREA :2312.96 SQ.FT <br />ARRAY AREA : 508.41 SQ.FT (22% OF ROOF AREA ) <br />(N) AC DISCONNECT <br />(N) COMBINER BOX <br />3' <br />1' <br />- <br />6 <br />" <br />4'-3" <br />5'-00" <br />22 <br />' <br />- <br />2 <br />" <br />24 <br />' <br />- <br />5 <br />" <br />11 <br />' <br />- <br />9 <br />" <br />3' <br />8' <br />- <br />6 <br />" <br />11 <br />' <br />- <br />4 <br />" <br />16 <br />' <br />- <br />1 <br />1 <br />" <br />23'-4" 6'-8" <br />16'-11" <br />2008 W 10th St - <br />2017725809/21/22