2319 N Flower St - Plan - Laserfiche WebLink

Home Browse Search

FASTER INSTALLATION. 25-YEAR WARRANTY. FLASH KIT PRO IS THE COMPLETE FLASHING AND ATTACHMENT SOLUTION FOR COMPOSITION ROOFS. FOR QUESTIONS OR CUSTOMER SERVICE VISIT UNIRAC.COM OR CALL (505) 248-2702 PRE-INSTALL • Locate roof rafters and snap chalk lines to mark the installation point for each roof attachment. • Drill a 7/32” pilot hole at each roof attachment. Fill each pilot hole with sealant. STEP 1 INSTALL FLASHKIT PRO FLASHING • Add a U-shaped bead of roof sealant to the underside of the ﬂashing with the open side of the U pointing down the roof slope. Slide the aluminum ﬂashing underneath the row of shingles directly up slope from the pilot hole as shown. Align the indicator marks on the lower end of the ﬂashing with the chalk lines on the roof to center the raised hole in the ﬂashing over the pilot hole in the roof. When installed correctly, the ﬂashing will extend under the two courses of shingles above the pilot hole. STEP 2 INSTALL L-FOOT • Fasten L-foot and Flashing into place by passing the included lag bolt and pre-installed stainless steel-backed EPDM washer through the L-foot EPDM grommet, and the raised hole in the ﬂashing, into the pilot hole in the roof rafter. • Drive the lag bolt down until the L-foot is held ﬁrmly in place. It is normal for the EPDM on the underside of the stainless steel backed EPDM washer to compress and expand beyond the outside edge of the steel washer when the proper torque is applied. TIP: • Use caution to avoid over-torqueing the lag bolt if using an impact driver. • Repeat Steps 1 and 2 at each roof attachment point. STEP 3 ATTACH L-FOOT TO RAIL • Insert the included 3/8"-16 T-bolts into the lower slot on the Rail (sold separately), spacing the bolts to match the spacing between the roof attachments. • Position the Rail against the L-Foot and insert the threaded end of the T-Bolt through the continuous slot in the L-Foot. Apply anti-seize to bolt threads to prevent galling of the T-bolt and included 3/8” serrated ﬂange nut. Place the 3/8” ﬂange nut on the T-bolt and ﬁnger tighten. Repeat STEP 3 until all L-Feet are secured to the Rail with a T-bolt. Adjust the level and height of the Rail and torque each bolt to 30ft-lbs. INSTALL FLASHKIT PRO FLASHING STEP 1 STEP 2 STEP 3 INSTALL L-FOOT ATTACH L-FOOT TO RAIL FLASHKIT PRO INSTALLATION GUIDE 2319 N Flower 05/17/22