Laserfiche WebLink
Page 6 of 8 <br /> <br />STEP 11: Apply UV rated sealant <br />around the threaded shaft and com- <br />press with a 3/8” washer included in <br />the kit. The 3/8” box-end wrench can <br />be used for this. <br />STEP 12: Apply UV rated sealant <br />around the top of the washer to com- <br />plete the waterproof tile seal. Now <br />the tile is completely waterproof. <br />Step 3b: Attaching / Sealing TileTrac® (Composition Roof) <br />STEP 2: Drill a 3/16” pilot hole to <br />depth of the lag bolt. <br />STEP 3: Apply a generous amount <br />of fresh sealant (polyurethane <br />based, such as Sikaflex 1-a recom- <br />mended) to the base. <br />Roofing mastic/sealant must be ap- <br />plied per manufacturer’s specifica- <br />tions. Mastic/sealant should be fresh <br />and applied at room temperature, as <br />necessary. <br />Date Modified: 09/12/07 <br />TileTrac <br />Installation Manual <br />® <br />Use of a 1/4” carbide tipped drill bit for breaking <br />through the rough composition shingle surface <br />only (not for pilot hole) will avoid premature pilot <br />hole drill bit wear. The use of two drills—one for <br />breaking through surface, one for pilot hole drill- <br />ing—to decrease drill time is recommended. <br />STEP 11 STEP 12 <br />STEP 1 STEP 2 STEP 3 <br />STEP 1: Using a precision stud <br />finder, locate the absolute center of <br />the rafter. Mark with a crayon/chalk. <br />See section 3a Install Tip for additional <br />methods for locating rafters. <br />2510 N. Hathaway <br />St05/26/22