Laserfiche WebLink
A <br />A <br />A <br />A <br />A <br />A <br />A <br />A <br />MOUNTING DETAIL <br />S-01SCALE:1"=10'-0" <br />NOTE:PENETRATIONS ARE STAGGERED <br />ADDRESS:513 S EVERGLADE ST, SANTA <br />ANA, CA 92704 <br />33.740912, -117.904046 <br />APN:109-78-142 <br />CUSTOMER INFORMATION <br />NAME:CECILIA TORRES <br />DATE:9/23/2022 <br />SCALE:AS NOTED REV:A <br />AHJ:CA - CITY OF SANTA ANA <br />UTILITY:SCE <br />PRN NUMBER:MAS-64170 <br />DRAFTED BY: <br />M.SAILESH <br />QC'ED BY:H.RAJ <br />PAPER SIZE:17"X11" <br />SOLARPLEX LLC <br />Dba MARAVILLA CONSTRUCTION <br /> License#:1056065 <br /> 5902 FIRESTONE BLVD <br /> SOUTH GATE, CA 90280 <br /> TEL:(562) 806-6000 <br /> FAX:(562) 806-4006 <br />INSTALLATION NOTES <br />1. STRUCTURAL ROOF MEMBER LOCATIONS ARE <br />ESTIMATED AND SHOULD BE LOCATED AND <br />VERIFIED BY THE CONTRACTOR WHEN LAG BOLT <br />PENETRATION OR MECHANICAL ATTACHMENT TO <br />THE STRUCTURE IS REQUIRED. <br />2. ROOFTOP PENETRATIONS FOR SOLAR RACKING <br />WILL BE COMPLETED AND SEALED WITH APPROVED <br />SEALANT PER CODE BY A LICENSED CONTRACTOR. <br />3. LAGS MUST HAVE A MINIMUM 2.5" THREAD <br />EMBEDMENT INTO THE STRUCTURAL MEMBER. <br />4. ALL PV RACKING ATTACHMENTS SHALL BE <br />STAGGERED BY ROW BETWEEN THE ROOF FRAMING <br />MEMBERS AS NECESSARY. <br />5. ROOF MOUNTED STANDARD RAIL REQUIRES ONE <br />THERMAL EXPANSION GAP FOR EVERY RUN OF RAIL <br />GREATER THAN 40'. <br />6. ALL CONDUCTORS AND CONDUITS ON THE ROOF <br />SHALL BE MINIMUM 7/8" ABOVE THE ROOF <br />SURFACE (INCLUDING CABLES UNDERNEATH <br />MODULES AND RACKING). <br />7. THE PV INSTALLATION SHALL NOT OBSTRUCT ANY <br />PLUMBING, MECHANICAL OR BUILDING ROOF <br />VENTS. <br />ROOF ACCESS PATHWAYS AND SETBACKS: <br />1204.2.1 SOLAR PHOTOVOLTAIC SYSTEMS FOR GROUP <br />R-3 BUILDINGS.SOLAR PHOTOVOLTAIC SYSTEMS FOR <br />GROUP R-3 BUILDINGS SHALL COMPLY WITH SECTIONS <br />1204.2.1.1 THROUGH 1204.2.1.3. <br />EXCEPTIONS: <br />1. THESE REQUIREMENTS SHALL NOT APPLY TO <br />STRUCTURES DESIGNED AND CONSTRUCTED IN <br />ACCORDANCE WITH THE CALIFORNIA RESIDENTIAL <br />CODE. <br />2. THESE REQUIREMENTS SHALL NOT APPLY TO ROOFS <br />WITH SLOPES OF 2 UNITS VERTICAL IN 12 UNITS <br />HORIZONTAL OR LESS. <br />1204.2.1.1 PATHWAYS TO RIDGE. NOT FEWER THAN <br />TWO 36-INCH-WIDE (914 MM) PATHWAYS ON SEPARATE <br />ROOF PLANES,FROM LOWEST ROOF EDGE TO RIDGE, <br />SHALL BE PROVIDED ON ALL BUILDINGS. NOT FEWER <br />THAN ONE PATHWAY SHALL BE PROVIDED ON THE <br />STREET OR DRIVEWAY SIDE OF THE ROOF. FOR EACH <br />ROOF PLANE WITH A PHOTOVOLTAIC ARRAY, NOT FEWER <br />THAN ONE 36-INCH-WIDE (914 MM) PATHWAY FROM <br />LOWEST ROOF EDGE TO RIDGE SHALL BE PROVIDED ON <br />THE SAME ROOF PLANE AS THE PHOTOVOLTAIC ARRAY, <br />ON AN ADJACENT ROOF PLANE OR STRADDLING THE <br />SAME AND ADJACENT ROOF PLANES <br />1204.2.1.2 SETBACKS AT RIDGE.FOR PHOTOVOLTAIC <br />ARRAYS OCCUPYING 33 PERCENT OR LESS OF THE PLAN <br />VIEW TOTAL ROOF AREA, <br />A SETBACK OF NOT LESS THAN 18 INCHES (457 <br />MM)WIDE IS REQUIRED ON BOTH SIDES OF A <br />HORIZONTAL RIDGE. FOR PHOTOVOLTAIC ARRAYS <br />OCCUPYING MORE THAN 33 PERCENT OF THE PLAN VIEW <br />TOTAL ROOF AREA, A SETBACK OF NOT LESS THAN 36 <br />INCHES (457 MM) WIDE IS REQUIRED ON BOTH SIDES <br />OF A HORIZONTAL RIDGE. <br />1204.2.2 EMERGENCY ESCAPE AND RESCUE OPENINGS. <br />PANELS AND MODULES INSTALLED ON GROUP R-3 <br />BUILDINGS SHALL NOT BE PLACED ON THE PORTION OF <br />A ROOF THAT IS BELOW AN EMERGENCY ESCAPE AND <br />RESCUE OPENING. A PATHWAY OF NOT LESS THAN 36 <br />INCHES (914 MM) WIDE SHALL BE PROVIDED TO THE <br />EMERGENCY ESCAPE AND RESCUE OPENING <br />1204.2.1.3 ALTERNATIVE SETBACKS AT RIDGE. <br />WHERE AN AUTOMATIC SPRINKLER SYSTEM IS <br />INSTALLED WITHIN THE DWELLING IN ACCORDANCE <br />WITH SECTION 903.3.1.3, SETBACKS AT THE RIDGE <br />SHALL CONFORM TO ONE OF THE FOLLOWING: <br />1. FOR PHOTOVOLTAIC ARRAYS OCCUPYING 66 PERCENT <br />OR LESS OF THE PLAN VIEW TOTAL ROOF AREA, A <br />SETBACK OF NOT LESS THAN 18 INCHES (457 MM) WIDE <br />IS REQUIRED ON BOTH SIDES OF A HORIZONTAL RIDGE. <br />2.FOR PHOTOVOLTAIC ARRAYS OCCUPYING MORE THAN <br />66 PERCENT OF THE PLAN VIEW TOTAL ROOF AREA, A <br />SETBACK OF NOT LESS THAN 36 INCHES (914 MM) WIDE <br />IS REQUIRED ON BOTH SIDES OF A HORIZONTAL RIDGE <br />ALUMINIUM RAILS <br />2 X 4 RAFTERS@ <br />2'-0"SPACING <br />ARRAY MP-01 <br />STRING CONFIGURATION <br />BRANCH DETAILS <br />A 8 MODULES <br />SITE INFORMATION - WIND SPEED: 95 MPH AND SNOW LOAD: 0 PSF <br />SR. <br />NO AZIMUTH PITCH NO. OF <br />MODULES <br />ARRAY AREA <br />(SQ. FT.)ROOF TYPE ATTACHMENT ROOF <br />EXPOSURE FRAME TYPE FRAME <br />SIZE <br />FRAME <br />SPACING <br />MAX RAIL <br />SPAN <br />OVER <br />HANG <br />MP-01 90° 20° 8 169.1 COMPOSITION <br />SHINGLE <br />IRONRIDGE <br />FLASHFOOT2 ATTIC RAFTERS 2 X 4 2'-0" 6'-0" 2'-0" <br />AERIAL VIEW <br />6' <br />3' <br />1'-6" <br />Structural <br />Only <br />513 S Everglade <br />Ave12/20/22