Laserfiche WebLink
SOLARMOUNT Technical Datasheets :i: UNI RAC <br />A HUJI GROUP COMPANY <br />SolarMount Technical Datasheet <br />Pub 110818-ltd Vl.0 August 2011 <br />SolarMount Module Connection Hardware 1 <br />Bottom Up Module Clip 1 <br />9Mid Clamp <br />End Clamp <br />SolarMount Beam Connection Hardware 3 <br />L,Foot 3 <br />SolarMount Beams 4 <br />SolarMount Module Connection Hardware <br />SolarMount Bottom Up Module Clip <br />Part No. 302000C <br />/Nut <br />Washer 1 <br />Bottom (hidden..se <br />Beam <br />1 <br />• Bottom Up Clip material: One of the following extruded aluminum <br />alloys: 6005-T5, 6105-T5, 6061-T6 <br />• Ultimate tensile: 38ksi, Yield: 35 ksi <br />· Finish: Clear Anodized <br />· Bottom Up Clip weight: -0.031 lbs (14g) <br />· Allowable and design loads are valid when components are; <br />assembled with SolarMount series beams according to authorized <br />UNIRAC documents <br />Assemble with one 14=-20 ASTM F593 bolt, one %"-20 ASTM F594 <br />serrated flange nut, and one M" flat washer <br />· Use anti-seize and tighten to 10 ft-lbs of torque <br />Resistance factors and safety factors are determined according to <br />part 1 section 9 of the 2005 Aluminum Design Manual and third- <br />party test results from an IAS accredited laboratory <br />Module edge must be fully supported by the beam <br />* NOTE ON WASHER: Install washer on bolt head side of assembly. <br />DO NOT install washer under serrated flange nut <br />Falm=p ,r U 1.24Y <br />A ball - --1.09 <br />- X <br />Applied Load Average Allowable Safety Design Resistance <br />Direction Ultimate Load Factor,Load Factor, <br />lbs (N)lbs (N)FS lbs (N) ® <br />Tension, Y+1566 (6967) 686 (3052)2.28 1038 (4615)0.662 <br />Transverse, X+ 1128 (5019) 329 (1463)3.43 497 (2213)0.441 <br />Sliding, Zi 66 (292)27(119)2.44 41(181)0.619 <br />Dimensions specified in ihches unless noted