Laserfiche WebLink
Tech Brief <br /> © 2016 IronRidge, Inc. All rights reserved. Visit www.ironridge.com or call 1-800-227-9523 for more information. Version 1.20 <br />More Resources <br />Installation Manuals <br />Visit our website for manuals that include UL <br />2703 Listing and Fire Rating Classification. <br />Go to IronRidge.com <br />Engineering Certification Letters <br />We offer complete engineering resources <br />and pre-stamped certification letters. <br />Go to IronRidge.com <br />Frequently Asked Questions <br />What is a “module type”? <br />The new UL1703 standard introduces the concept of a <br />PV module type, based on 4 construction parameters <br />and 2 fire performance parameters. The purpose of <br />this classification is to certify mounting systems without <br />needing to test it with every module. <br />What roofing materials are covered? <br />All fire rated roofing materials are covered within this <br />certification including composition shingle, clay and <br />cement tile, metal, and membrane roofs. <br />What if I have a Class C roof, but the jurisdiction <br />now requires Class A or B? <br />Generally, older roofs will typically be “grandfathered <br />in”, and will not require re-roofing. However, if 50% or <br />more of the roofing material is replaced for the solar <br />installation the code requirement will be enforced. <br />Where is the new fire rating requirement code listed? <br />2012 IBC: 1509.7.2 Fire classification. Rooftop <br />mounted photovoltaic systems shall have the same fire <br />classification as the roof assembly required by Section <br />1505. <br />Where is a Class A Fire Rating required? <br />The general requirement for roofing systems in the IBC <br />refers to a Class C fire rating. Class A or B is required for <br />areas such as Wildland Urban Interface areas (WUI) and <br />for very high fire severity areas. Many of these areas are <br />found throughout the western United States. California <br />has the most Class A and B roof fire rating requirements, <br />due to wild fire concerns. <br />Are standard mid clamps covered? <br />Mid clamps and end clamps are considered part of the <br />PV “system”, and are covered in the certification. <br />What attachments and flashings are deemed <br />compatible with Class A? <br />Attachments and their respective flashings are not <br />constituents of the rating at this time. All code-compliant <br />flashing methods are acceptable from a fire rating <br />standpoint. <br />What mounting height is acceptable? <br />UL fire testing was performed with a gap of 5”, which is <br />considered worst case in the standard. Therefore, the <br />rating is applicable to any module to roof gap. <br />Am I required to install skirting to meet the fire <br />code? <br />No, IronRidge achieved a Class A fire rating without any <br />additional racking components. <br />What determines Fire Classification? <br />Fire Classification refers to a fire-resistance rating <br />system for roof covering materials based on their ability <br />to withstand fire exposure. <br />Class A - effective against severe fire exposure <br />Class B - effective against moderate fire exposure <br />Class C - effective against light fire exposure <br />What if the roof covering is not Class A rated? <br />The IronRidge Class A rating will not diminish the fire <br />rating of the roof, whether Class A, B, or C. <br />What tilts is the tilt mount system fire rated for? <br />The tilt mount system is rated for 1 degrees and up and <br />any roof to module gap, or mounting height. <br />2314 W San Lorenzo <br />Ave11/17/2023