|
RI
<br />D
<br />
<br />2
<br />2
<br />4
<br />2
<br />2
<br />
<br />-
<br />
<br />H
<br />E
<br />A
<br />T
<br />H
<br />E
<br />R
<br />
<br />R
<br />U
<br />H
<br />L
<br />PH
<br />O
<br />T
<br />O
<br />V
<br />O
<br />L
<br />T
<br />A
<br />I
<br />C
<br />
<br />S
<br />Y
<br />S
<br />T
<br />E
<br />M
<br />24
<br />0
<br />4
<br />
<br />E
<br />
<br />B
<br />U
<br />F
<br />F
<br />A
<br />L
<br />O
<br />
<br />A
<br />V
<br />E
<br />,
<br />SA
<br />N
<br />T
<br />A
<br />
<br />A
<br />N
<br />A
<br />,
<br />
<br />C
<br />A
<br />
<br />9
<br />2
<br />7
<br />0
<br />5
<br />AP
<br />N
<br />
<br />3
<br />9
<br />6
<br />2
<br />8
<br />2
<br />1
<br />3
<br />5205 AVENIDA ENCINAS STE
<br />D, CARLSBAD, CA 92008
<br />LICENSE: # 1063901
<br />LICENSE TYPE: A/B
<br />LICENSE: # 1063901
<br />LICENSE TYPE: C-10
<br />GENERAL NOTES:
<br />ALL EQUIPMENT SHALL BE LISTED AND LABELED BY A
<br />RECOGNIZED ELECTRICAL TESTING LABORATORY AND
<br />C.A. TEST LAB. EQUIPMENT INSTALLED SHALL BE PER ITS
<br />LISTING REQUIREMENTS AND THE MANUFACTURER'S
<br />INSTRUCTIONS. [NEC 110.2, 110.3,
<br />690.4(B), 690.12(D)]
<br />ALL OUTDOOR EQUIPMENT SHALL BE NEMA 3R RATED,
<br />INCLUDING ALL ROOF MOUNTED TRANSITION BOXES AND
<br />SWITCHES. · ALL EQUIPMENT SHALL BE PROPERLY
<br />GROUNDED AND BONDED IN ACCORDANCE WITH NEC
<br />ARTICLE 250.
<br />ALL PV CIRCUITS CONNECTED AND EQUIPMENT SHALL BE
<br />PROTECTED AGAINST OVERCURRENT. OVERCURRENT
<br />DEVICES SHALL BE LISTED FOR USE IN PV SYSTEMS.
<br />OVERCURRENT PROTECTIVE DEVICES SHALL NOT BE
<br />REQUIRED FOR CIRCUITS WITH SUFFICIENT AMPACITY
<br />FOR THE HIGHEST AVAILABLE
<br />CURRENT. CIRCUITS CONNECTED TO CURRENT LIMITED
<br />SUPPLIES AND ALSO CONNECTED TO SOURCES HAVING
<br />HIGHER CURRENT AVAILABILITY SHALL BE PROTECTED AT
<br />THE HIGHER CURRENT
<br />SOURCE CONNECTION. [NEC 690.9]
<br />DISCONNECTING MEANS OF THE PV SYSTEM (INCLUDING
<br />RAPID
<br />SHUTDOWN INITIATION) SHALL BE LOCATED IN A READILY
<br />ACCESSIBLE LOCATION NEAR THE EQUIPMENT. [NEC
<br />690.13,690.15]
<br />RAPID SHUTDOWN EQUIPMENT TO COMPLY WITH NEC
<br />690.12.
<br />ENERGY STORAGE SYSTEM TERMINALS LOCATED MORE
<br />THAN 5 FEET AWAY OR ON OPPOSITE SIDE OF WALL FROM
<br />CONNECTED EQUIPMENT MUST HAVE DISCONNECTING
<br />MEANS IN ACCORDANCE WITH NEC 706.7(E) AND LABELED
<br />PER 706.7(D). A SECOND
<br />DISCONNECTING MEANS LOCATED AT THE CONNECTED
<br />EQUIPMENT SHALL BE INSTALLED WHERE THE
<br />DISCONNECTING MEANS AT THE ESS END OF THE CIRCUIT
<br />IS NOT WITHIN SIGHT.
<br />THE UTILITY-INTERACTIVE INVERTERS SHALL
<br />AUTOMATICALLY DE-ENERGIZE ITS OUTPUT TO THE
<br />CONNECTED ELECTRICAL PRODUCTION AND
<br />DISTRIBUTION NETWORK VOLTAGE HAS BEEN
<br />RESTORED. [NEC 705.40]
<br />ALL CONDUCTORS IN EXPOSED OUTDOOR LOCATIONS
<br />SHALL BE LISTED AND IDENTIFIED FOR USE IN DIRECT
<br />SUNLIGHT AND FOR THE APPLICATION. [NEC 690.31(C)
<br />THROUGH (F), 310.10(D)]
<br />INSULATION OF EXPOSED CONDUCTORS UNDER THE
<br />MODULES SHALL BE USE-2 OR PV-WIRE TYPE FOR PV
<br />SYSTEMS (UL 4703 & 854 LISTED) [NEC 690.31(C)]
<br />FINE-STRANDED CABLE CONNECTIONS MUST BE MADE IN
<br />LUGS AND TERMINALS TO ENSURE A THOROUGHLY GOOD
<br />CONNECTION WITHOUT DAMAGING THE CONDUCTORS.
<br />[NEC 110.14(A)]
<br />FLEXIBLE, FINE-STRANDED CABLES SHALL BE
<br />TERMINATED ONLY WITH TERMINALS, LUGS, DEVICES, OR
<br />CONNECTORS THAT ARE IDENTIFIED AND LISTED FOR
<br />SUCH USE. [NEC 690.31(H), 110.14]
<br />ALL PV CIRCUIT CONDUCTORS SHALL BE MARKED ON
<br />EACH END AND GROUPED FOR UNIQUE IDENTIFICATION.
<br />[NEC 690.31(B)] · ALL EXTERIOR CONDUIT, FITTINGS, AND
<br />BOXES SHALL BE RAIN
<br />TIGHT AND APPROVED FOR USE IN WET LOCATIONS. [NEC
<br />314.15]
<br />ALL GROUNDED, (NEUTRAL), CONDUCTORS' INSULATION
<br />SHALL BE SOLID WHITE, GRAY, OR WITH 3-WHITE STRIPES.
<br />[NEC 200.6, 200.7, 400.22]; ALL GROUNDING CONDUCTORS
<br />SHALL BE OF BARE WIRE WITHOUT COVERING, OR WITH
<br />INSULATION OF GREEN OR GREEN WITH YELLOW STRIPES,
<br />NEC 250.119 & 400.23. THE COLOR OF UNGROUNDED
<br />CONDUCTORS SHALL BE OTHER THAN FOR GROUNDED,
<br />(NEUTRAL), AND GROUNDING CONDUCTORS. [NEC
<br />310.110(C)]
<br />MAXIMUM CONDUCTOR LENGTH BETWEEN SUPPLY SIDE
<br />CONNECTION AND OVERCURRENT PROTECTION IS 10FT.
<br />[NEC 705.31]
<br />CONNECTIONS ON THE LOAD SIDE OF THE SERVICE
<br />DISCONNECTING MEANS OF THE OTHER SOURCE(S) AT
<br />ANY DISTRIBUTION EQUIPMENT ON THE PREMISES SHALL
<br />BE IN ACCORDANCE WITH NEC 705.12(B).
<br />DC WIRING INSIDE A BUILDING MUST BE IN METALLIC TYPE
<br />RACEWAYS, CONDUITS,ENCLOSURES, OR CABLE
<br />SHEATHINGS. [NEC 690.31(G)] · METALLIC TYPE
<br />RACEWAYS, CONDUITS, ENCLOSURES, AND CABLE
<br />SHEATHS CONTAINING CIRCUITS OVER 250-VOLTS TO
<br />GROUND MUST BE BONDED IN ACCORDANCE WITH NEC
<br />250.97.
<br />CONNECTORS SHALL BE OF LATCHING OR LOCKING TYPE.
<br />CONNECTORS THAT ARE READILY ACCESSIBLE AND
<br />OPERATING AT OVER 30-VOLTS SHALL REQUIRE A TOOL
<br />TO OPEN AND MARKED "DO NOT DISCONNECT UNDER
<br />LOAD" OR "NOT FOR CURRENT INTERRUPTING." [NEC
<br />690.33(C) & (E)(2)]
<br />FOR PV MODULES, EQUIPMENT GROUNDING CONDUCTOR
<br />(EGC) SMALLER THAN #6-AWG SHALL BE PROTECTED
<br />FROM PHYSICAL DAMAGE BY AN IDENTIFIED RACEWAY OR
<br />CABLE ARMOR, UNLESS INSTALLED WITHIN HOLLOW
<br />SPACES OF THE FRAMING MEMBERS OF BUILDINGS OR
<br />STRUCTURES AND WHERE NOT SUBJECT TO PHYSICAL
<br />DAMAGE. [NEC
<br />690.46, 250.120(C)]
<br />THE INTERCONNECTION POINT SHALL BE ON THE SUPPLY
<br />SIDE OF ALL GROUND-FAULT PROTECTION EQUIPMENT.
<br />[NEC 705.32]
<br />CABLES/WIRES THAT ARE SUBJECT TO PHYSICAL
<br />DAMAGE, SUCH AS THOSE NOT LOCATED UNDER THE
<br />MODULES, MUST BE PROTECTED. [NEC 300.4]
<br />FOR ELECTRICAL SERVICE REPLACEMENTS, BONDING TO
<br />THE METAL PIPES OF NATURAL GAS, HOT WATER, AND
<br />COLD WATER MUST BE PROVIDED. [NEC 250.104]
<br />GROUNDING ROD ELECTRODES SHALL BE INSTALLED 8-FT
<br />MINIMUM IN CONTACT WITH SOIL AND MINIMUM 5/8-INCH
<br />DIAMETER. [NEC 250.52(A)(5), 250.53(G)] ·
<br />THE MARKINGS, "WARNING: PHOTOVOLTAIC POWER
<br />SOURCE", FOR DC RACEWAYS AND CABLE ASSEMBLIES
<br />MUST BE NO MORE THAN 10-FT O.C.; AND IS SEPARATED
<br />BY ENCLOSURES, WALLS, PARTITIONS, CEILINGS, FLOORS,
<br />OR BENDS ABOVE OR BELOW
<br />PENETRATIONS. [NEC 690.31(G)(3)&(4)]
<br />WORKING CLEARANCES TO BE PROVIDED AT NEW AND
<br />EXISTING ELECTRICAL EQUIPMENT. [NEC 110.26] · POWER
<br />PRODUCTION SYSTEMS, AND ALL ASSOCIATED WIRING
<br />AND INTERCONNECTIONS OPERATING IN PARALLEL WITH
<br />A PRIMARY POWER SOURCE SHALL BE PERFORMED ONLY
<br />BY QUALIFIED PERSONS. [NEC 690.4(C), 705.8]
<br />LABELS SHALL BE REFLECTIVE, AND ALL LETTERS SHALL
<br />BE CAPITALIZED AND SHALL BE A MINIMUM HEIGHT OF 3/8"
<br />IN WHITE ON A RED BACKGROUND. [NEC 690.31(G)(4)]
<br />IDENTIFICATION OF POWER SOURCE RAPID SHUTDOWN
<br />AND LABELING SHALL BE IN ACCORDANCE WITH NEC
<br />690.56(C). · SMOKE ALARMS AND CARBON MONOXIDE
<br />ALARMS ARE REQUIRED TO BE RETROFITTED ONTO THE
<br />EXISTING DWELLING AS PER THE 2019 CRC. THESE SMOKE
<br />ALARMS ARE REQUIRED TO BE IN ALL BEDROOMS,
<br />OUTSIDE EACH BEDROOM, AND AT LEAST ONE ON EACH
<br />FLOOR OF THE HOUSE. CARBON MONOXIDE ALARMS ARE
<br />REQUIRED TO BE
<br />RETROFITTED OUTSIDE EACH BEDROOM AND AT LEAST
<br />ONE ON EACH FLOOR OF THE HOUSE (CRC 314,315)
<br />SMOKE ALARMS AND CARBON MONOXIDE ALARMS ARE
<br />REQUIRED PER CRC SECTIONS 314 AND 315 TO BE
<br />VERIFIED AND INSPECTED BY THE INSPECTOR IN THE
<br />FIELD.
<br />A LADDER MUST BE PROVIDED FOR INSPECTIONS IN
<br />ACCORDANCE WITH Cal-OSHA REGULATIONS, SECURED
<br />AND EXTENDING 3-FT ABOVE THE ROOF.
<br />ALL OF THE REQUIRED MARKINGS, SIGNS, AND LABELS
<br />MUST BE INSTALLED ON ALL EQUIPMENT PRIOR TO ANY
<br />INSPECTIONS
<br />PHOTOVOLTAIC MODULES AND PANEL SYSTEMS
<br />INSTALLED ON OR INTEGRAL WITH BUILDINGS, OR TO BE
<br />FREESTANDING (NOT ATTACHED TO BUILDINGS) SHALL BE
<br />TESTED, LISTED, AND IDENTIFIED WITH A FIRE
<br />CLASSIFICATION (CLASS C MINIMUM) IN ACCORDANCE
<br />WITH UL1703. WHERE CLASS A OR B ROOFING IS
<br />REQUIRED, THE PV SOLAR SYSTEM (PV PANEL & RACK)
<br />SHALL HAVE THE SAME CLASS/TYPE RATING OR BETTER.
<br />PERMANENT SIGNAGE TO BE RED WITH WHITE LETTERS
<br />OCCUPANCY GROUP: R3
<br />CONSTRUCTION TYPE: V-B
<br />ALL WORK DONE IN A NEAT AND WORKMANLIKE MANNER
<br />BUILDING
<br />AREA 2563
<br />STORIES 2
<br />HEIGHT 20
<br />YEAR BUILT 1963
<br />PV-1
<br />TITLE PAGE
<br />SYSTEM INFORMATION
<br />SYSTEM SIZE 6400 WATTS DC
<br />5920 WATTS AC
<br />MODULES 16 Q.PEAK DUO BLK ML-G10+400
<br />INVERTER(S) 16 ENPHASE IQ7PLUS-72-2-US
<br />BATTERY N/A N/A
<br />SCOPE OF WORK
<br />PROVIDE AND INSTALL SOLAR
<br />PHOTOVOLTAIC ROOF MOUNT 200 /
<br />200 MAIN SERVICE PANEL UPGRADE
<br />CODE INFORMATION
<br />ALL MATERIALS, EQUIPMENT, INSTALLATION AND WORK
<br />PERFORMED SHALL BE IN ACCORDANCE WITH THE
<br />FOLLOWING CODES:
<br />2019 CBC 2019 IBC
<br />2019 CRC 2019 IRC
<br />2019 CEC 2019 NEC
<br />2019 CMC 2019 IMC
<br />2019 CPC 2019 IPC
<br />2019 CFC 2019 IFC
<br />2019 BUILDING EFFICIENCY STANDARDS
<br />SHEET INDEX
<br />PV-1 TITLE PAGE
<br />PV-2 SITE PLAN
<br />PV-2.1 ROOF PLAN
<br />PV-3 ATTACHMENT DETAIL
<br />PV-4 SINGLE LINE
<br />PV-5 LABELS AND WARNING SIGNAGE
<br />PV-6 MODULE SPEC SHEET
<br />PV-6.1 INVERTER SPEC SHEET
<br />PV-6.2 CERTIFICATE OF COMPLIANCE
<br />PV-6.3 ENPHASE COMBINER SPEC SHEET
<br />PHOTOVOLTAIC SYSTEM FOR
<br />NAME:HEATHER RUHL
<br />ADDRESS:2404 E BUFFALO AVE
<br />A.P.N 39628213
<br />JURISDICTION SANTA ANA
<br />Bldg# 101113770
<br />Elec# 20178656
<br />Issued 02/14/23
<br />The scope of the plans is for the installation of the solar photovoltaic
<br />system only and the approval is subject to compliance with all
<br />applicable city and state codes and regulations regarding construction.
<br />The approval of the plans does not constitute any certification of the
<br />accuracy, completeness, or building permit status of the existing
<br />buildings and structures as shown.
<br />2404 E Buffalo Ave
<br />02/15/23
|