Laserfiche WebLink
�IRONRIDGE <br />( 3.56 ) <br />( 1.02) <br />( 3.67) i <br />THIS EDGE TOWARDS ROOF RIDGE <br />( 12.00) <br />( 3.00) <br />4.50 <br />___ __, 9 .00 ,___ _ _____,_ <br />NO. DESCRIPTION <br />1 ASSY, FLASHING, MILL OR BLACK <br />2 ASSY, CAP, MILL OR BLACK <br />3 BOLT LAG 5/16 X 4.75" <br />4 WASHER, EPDM BACKED <br />© 2016 lronRidge, Inc. All rights reserved. Visit www.ironridge.com or call 1-800-227-9523 for more information. <br />FlashFoot2 <br />KIT, FLASHFOOT2 <br />SIZE A DO NOT SCALE DRAWING <br />SCALE:1:4 WEIGHT: 0.881bs SHEET l OF 1 <br />FM-FF2-MAN REV 1.20 <br />Installation <br />Tools Required: tape measure, chalk line, stud finder, roofing bar, caulking gun, driver with 1 /4" bit and 7 /16" <br />hex socket. <br />II I I <br />I I <br />R1fter I I :::: <br />I I <br />I I <br />I I <br />I I <br />I I <br />I I I I I I I I <br />Locate rafters and snap vertical and horizontal lines <br />to mark flashing locations. Drill 1 /4" pilot holes, then <br />fill with roofing manufacturer's approved sealant. <br />Line up pilot hole with flashing hole and insert lag <br />bolt with bonded washer through flashing. Tighten <br />lag bolt until fully seated. <br />Attach rails to either side of the open slot using <br />bonding hardware. Level rail at desired height, then <br />torque to 250 in-lbs (21 ft-lbs). <br />- -, <br />; 3r' course • <br />2nd course <br />1 t course <br />Slide flashing, between 1st and 2nd course, so the <br />top is at least 3/4" above the edge of the 3rd course <br />and the bottom is above the edge of the 1st course. <br />Place Cap onto flashing in desired orientation for <br />E/W or N/S rails and rotate 180 degrees. FlashFoot <br />2 is now installed and ready for lronRidge XR Rails. <br />Structural Certification <br />Designed and Certified for Compliance with the International <br />Building Code &ASCE/SEl-7. Water Seal Ratings <br />Water Sealing Tested to UL 441 Section 27 "Rain Test" and <br />TAS 100-95 "Wind Driven Rain Test" by lntertek. Ratings <br />applicable for composition shingle roofs having slopes between <br />2:12 and 12:12. Tested and evaluated without sealant. Any <br />roofing manufacturer approved sealant is allowed. UL 2703 <br />Conforms to UL 2703 Mechanical and Bonding Requirements. <br />See lronRidge Flush Mount Installation Manual for full ratings. <br />© 2016 lronRidge, Inc. All rights reserved. Visit www.ironridge.com or call 1-800-227-9523 for more information. FM-FF2-MAN REV 1.20 <br />929 E Jonquil Rd - <br />2018144011/27/2023