Laserfiche WebLink
© 2020 IRONRIDGE, INC. VERSION 3.2 FLUSH MOUNT INSTALLATION MANUAL - 7 <br />B. PLAC e MODUL e <br />Place module on rails (module cells not shown for <br />clarity). When installing CAMO the module can <br />overhang the rail no more than 1/4". <br />D. S eCUR e TO FRAMe <br />Rotate handle with an upwards motion until CAMO <br />snaps into rail channel. Ensure CAMO bonding <br />pins are fully seated on top of module frame. <br />CAMO <br />A. SLID e INTO RAIL <br />Slide CAMO into rail channel far enough to clear the <br />module frame. CAMO requires 6" of clearance from end of <br />rail. <br />C. PULL TOWARDS e ND <br />Pull CAMO towards rail ends, at 45 degree angle, so the <br />bonding bolt contacts the module flange edge. <br />B <br />C D <br />A <br />6" Cle <br />a <br />r <br />a <br />n <br />c <br />e <br />8" BONDING JUMP e R <br />8" Bonding Jumper is an electrical bonding jumper that can <br />be used on the Flush Mount System for row to row bonding; <br />making the module frames the medium for the equipment <br />ground path. <br /> ➢Bonding jumper is pushed onto the bottom flange of the module. <br /> <br /> ➢New jumpers should be used if re-installation of jumper is required. <br /> <br /> ➢Supports bottom flange thicknesses from 1.2mm to 3.1mm. <br />FRAMe COMPATIBILITY <br />CAMO has been tested or evaluated with all modules listed in the <br />Module Compatibility section having frames within the referenced <br />dimensions. Be sure the specific module being used meets the <br />dimension requirements. <br /> ➢For installations with Hanwha Q CeLLS modules with 32 mm frame heights, <br />the maximum ground snow is 45 PSF (33 PSF module pressure). <br /> ➢CAMO is only compatable with Canadian Solar module CS1YxxxMS. “xxx” <br />refers to the module power rating <br />3000 S Sycamore St Unit# <br />A- 201822724/29/2024