Laserfiche WebLink
© 2020 IRONRIDGE, INC. VERSION 3.2 FLUSH MOUNT INSTALLATION MANUAL - 10 <br />COMPOSITION SHINGL e <br />Locate roof rafters and mark locations on roof. Drill 1/4" <br />pilot holes perpendicular to the roof and back fill with <br />roofing manufacturers' approved sealant. Slide flashing <br />between 1st and 2nd course of shingles, ensuring both <br />that the flashing reaches under the 3rd shingle course and <br />doesn't overhang the downhill shingle course. Line up with <br />pilot hole and insert supplied lag bolt with washer through <br />flashing. With a 7/16" Socket fully seat lag bolt. Place Cap <br />onto flashing in desired orientation for E/W or N/S rails and <br />rotate 180 degrees until it locks into place. <br /> ➢Rail can be installed on either side of FlashFoot2 Cap. <br /> ➢For additional details refer to the full FlashFoot2 Installation <br />Manual. <br />FLASHFOOT2 <br />FLASHVU e <br />Locate rafters and snap vertical and horizontal lines to <br />mark locations of flashings. Drill 1/4” pilot holes, then <br />backfill with an approved sealant. Slide flashing between <br />1st and 2nd course of shingles, ensuring both that the <br />flashing reaches under the 3rd shingle course and doesn't <br />overhang the downhill shingle course. Line up pilot hole <br />with View Port. Press Grip Cap onto flashing in desired <br />orientation for E/W or N/S rails. Insert Lag Bolt with <br />mechanically bonded washer through flashing. With a <br />7/16" Socket drive Lag Bolt until fully seated. FlashVue <br />is now installed and ready for IronRidge XR Rails. <br />Attach rails to either side of the open slot using bonding <br />hardware. Level rail at desired height, then torque to 250 <br />in-lbs (21 ft-lbs). <br />When installing Gripcap+ on roofs with undulations greater <br />than 1 inch, install GripCap+ in low points across the array <br />as required. <br /> ➢For additional details refer to the full FlashVue Installation <br />Manual. <br /> ➢For additional details on the GripCap+ refer to the full GripCap+ <br />Installation Manual. <br />Torque to <br />250 in-lbs <br />3000 S Sycamore St Unit# <br />A- 201822724/29/2024