2961 3%4 W MacArthur Blvd WCC01 - Plan

Home Browse Search

These photos shall also certify that the placement and geo equipment on the mount is as depicted in the antenna pla, CITY OF SANTA ANA Planning and Building Agency To� may, lS. Approved tfy0oR&61RMIT ISSUANCE lent diagram in this form. Master ID: o Photos that show the model number of each antenna and piece of qWpment installed per sector. Antenna & equipment placement and Geometry Confirmation: • The contractor shall certify that the antenna & equipment placement and geometry is in accordance with the sketch and table as included in the mount analysis and noted below. ❑ The contractor certifies that the photos support and the equipment on the mount is as depicted on the sketch and table included in this form and with the mount analysis provided. MW ❑ The contractor notes that the equipment on the mount is not in accordance with the sketch and has noted the differences below and provided photo documentation of any alterations. Special Instructions / Validation as required from the MA or any other information the contractor deems necessary to share that was identified: Issue: Contractor shall record all dimensions and member sizes requested in the Mount Geometry Verification Requirements section of the Mount Analysis report. Contractor shall provide the requested information to Colliers Engineering & Design for structural verification while on site. Contact FOR if these documents are not available to the general contractor. Contractor shall inspect climbing facilities and safety climb, if present, and ensure they are in good condition. Contractor shall install safety climb wire rope guides in locations where wire rope is rubbing against the mount or mount -to -tower connection steel. Wire brush clean any observed corrosion and protect with two (2) coats of cold galvanization (Zings or Zinc Kote). Contractor shall provide photos of wire rope guide installation as part of PMI documents. Contact FOR if additional guidance is required. Kesponse: Special Instruction Confirmation: ❑ The contractor has read and acknowledges the above special instructions. ❑ All hardware listed in the Special Instructions above (if applicable) has been properly installed, and the existing hardware was inspected.