Laserfiche WebLink
*,,SANTA <br />NA <br />ILT\INC <br />Itltutic <br />.{ciln <br />Planning & Bullding Agency <br />Building Satoty Divislon <br />20 Clvic Center Plaza <br />P.O. Box 1988 (M-'19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />www.sanla-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />E <br />sol-01 cBc 2013 <br />Solar Photovoltalc (PV) Checktist for Detached STNGLE FAMtLy RESTDENCES Onty <br />lnstruclions: The licensed contractor of rscord shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to 6ach oi TWO sets of plans, of <br />minimum11"x17"size. lf answorino NOtoanvof the ouestions, plancheckshall b6 reouired. <br />Proje ct Address: 1 I 17 S. HALLADAY ST, SANTA ANA, CA 92701 <br />Conlractor Company Name: <br />Contracloi License Number: <br />SOUTHWEST SUN SOLAR, INC <br />Etr <br />1004667 <br />YES NO Are the following applicable to the proposed project? <br />2 Etr <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the Califomia Fire Code, and is this shown on the roof ptan? <br />Will the PV system be installed on a roof having only one roofng layer with no <br />ovedays? <br />Will the PV anay be flush mounled to the existing roof so that the plane of the <br />modules (panels) are parall6l to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installad where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum b€tween <br />the underside of modules and the surface of the roof? <br />Will the PV system bs installed without uslng any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing ol 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16'lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed pmfessional engineer? (including project specific sile plan, pV layout, <br />3 8tr <br />4 Ertr <br />Etr <br />6 EEI <br />7. Eltr <br />S. Etr <br />9. Etr <br />10 EE <br />anchorage spacing, anchorage delails and manu <br />I certify under penalty of periury undar the laws of lhe State of <br />pr1n1 116ms. TRANG CONG PHAM Signatur€: <br />phone Number: 714 582 3909 Date: <br />facture/s <br />California <br />ation.) <br />true <br />Ema it Address: PERMIT@SOUTHWESTSUNSOLAR.COM <br />Rev:8/1712015 <br />5 tg <br />l