Laserfiche WebLink
SOLARMOUNT Technical Datasheets ma UNIMAL <br />A rm.;'1 ':'ROUP (OMPANY <br />SolarMount Technical Datasheet <br />Pub 110818-ltd Vl.0 August 2011 <br />SolarMount Module Connection Hardware 1 <br />Bottom Up Module Clip 1 <br />Mid Clamp 2 <br />End Clamp 2 <br />SolarMount Beam Connection Hardware 3 <br />L-Foot 3 <br />SolarMount Beams 4 <br />SolarMount Module Connection Hardware <br />SolarMount Bottom Up Module Clip <br />Part No. 302000C <br />Bottom <br />\Nasher -Bottom Up Clip material: One of the following extruded aluminum <br />Nut (hidden..ge alloys: 6005-T5, 6105-T5, 6061-T6 <br />note$) •Ultimate tensile: 38ksi, Yield: 35 ksi <br />· Finish: Clear Anodized <br />• Bottom Up Clip weight: -0.031 lbs (14g) <br />· Allowable and design loads are valid when components are <br />assembled with SolarMount series beams according to authorized <br />UNIFU\C documents <br />· Assemble with one W'-20 ASTM F593 bolt, one 1,1,1-20 ASTM F594 <br />serrated flange nut, and one 16" flat washer <br />Use anti-seize and tighten to 10 ft-lbs of torque <br />Resistance factors and safety factors are determined according to <br />part 1 section 9 of the 2005 Aluminum Design Manual and third- <br />party test results from an IAS accredited laboratory <br />· Module edge must be fully supported by the beam <br />#A up clip / <br />Beam <br />El <br />* NOTE ON WASHER: Install washer on bolt head side of assembly. <br />DO NOT install washer under serrated flange nut <br />K...I-90. 11.24 <br />Y ;1 <br />A .X· 2 - '·CO <br />Applied Load Average Allowable Safety Design Resistance <br />Direction Ultimate Load Factor,Load Factor, <br />lbs (N)lbs (N)FS lbs (N) 0 <br />Tension, Y+1566 (6967)686 (3052)2.28 1038 (4615)0.662 <br />Transverse, Xi 1128 (5019)329 (1463)3.43 497 (2213)0.441 <br />Sliding, Zt 66 (292)27 (119)2.44 41 (181)0.619 <br />Dimensions specified in inches unless noted <br />e