Laserfiche WebLink
*-SNTA <br />ANA,"ffi <br />Planning & Building Agency <br />Building Safety Division <br />20 Clvic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />2 <br />3 <br />4 <br />sol-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist Ior Detached StNcLE FAMILy RESTDENCES Only <br />lnstructions: The licensed contractor of record shall complete all seclions, answer the len questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO s ets of plans, of <br />minimum 11" x 17" size. lf answerinq NO to any of the queslions. plan check shall be required <br />Prorect Address:2201 HUCKLEBERRY RD, SANTAANA, CA92706 <br />contractor company Hame: SOUTHWEST SUN SOLAR, INC <br />contractorLiconseNumber: 1004667 <br />YES NO Are the following applicable to the proposed project? <br />Will the PV systsm layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the Califomia Fire Code, and is this shown on the roof plan? <br />Will the PV syslem be installed on a roof having only one rooJing layerwith no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to tho plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 1O', maximum between <br />the underside of modules and lhe surface of the roof? <br />Will the PV syslem be installed without using any bailast system or counter-weight <br />system? <br />Will the anchors be installed wilh a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, pV layout, <br />anchorage spacing, anchorage details and manufacture/s pV support information.) <br />a tr <br />8 tstr <br />9. Etr <br />10.EE <br />I certify under penalty of perjury under the laws of the State of California that <br />8tr <br />Eltr <br />tstr <br />Ettr <br />Ettr <br />atr <br />6 <br />7 <br />Prinr Name: MlMl NGO Signature: <br />Date:Phone Number: 714 582 3909 <br />Email Address <br />Rev:8/1712015 <br />PERM IT@SOUTHWESTSUNSOLAR.COM <br />he(,a bfftstruel