10181144_1554 BROOKHOLLOW #A - Plan

Home Browse Search

£11 , . Certificate of Compliance (Sign Lighting)(Page 2 of 4)SLTG-IC Project Name:Date: 3. Mandatory Sign Lighting Controls NOTES: 1. The Mandatory Measures (sign lighting controls) are required for compliance with the sign lighting Standards. The same responsible person may install both the sign and the sign lighting controls, or a di#erent responsible person may install the sign lighting controls than the responsible person installing the sign. 2. If the person responsible for installing the sign is not also responsible for the sign lighting controls, then the owner of the sign, general contractor, or architect shall be responsible to have the sign lighting controls installed 3. If more than one person has responsibility for compliance, each person shall prepare and sign a Certificate of Compliance and an Installation Cer©cate applicable to the portion of construction for which they are responsible; alternatively, the person with chief responsibility for construction shall prepare and sign the Certificate of Compliance Declaration Statement for the entire construction. 3a. Statements of Responsibility: The person signing the Certificate of Compliance Declaration Statement shall check Yes or No for all ofthe following statements: ve responsibility for installing the sign lighting controls 'es, complete parts 3a and 3b ofthis form O No, complete part 3a ofthis form ere are no existing sign lighting controls and I will be installing compliant sign lighting controls Yes O No :re are no existing sign lighting controls and someon; else will be responsible to install compliant sign lighting controls 3 0 Yes t*j,No There are existing sign lighting controls that do not coniply with the applicable provision of §119 and §133 agd I will be 4 installing compliant sign lighting controls OYes There are existing sign lighting controls that do not comply with the applicable provision of §119 and §133 and someone else 5 will be responsible to install compliant sign lighting KfrolsO Yes 2,4 No M .No 3b. Mandatory Sign Lighting Controls The person signing the Certificate of Compliance Declaration Statement shall answer all ofthe following questions ifthey are responsible for complying with the sign lighting control requirements. If there are construction documents, indicate where on the building plans the mandatory measures (sign lighting control) note block can be located: 1 §133(a)1. All indoor sign lighting is controlled with an automatic time switch control that complies with the Y applicable requirements of #119. §133(a)1 and 2. All outdoor sign lightihg is controlled with an automatic time switch control plus a photo ·2 control, or an outdoor astronomical time switch, that comply with.the.applicable requirements of §119. Exception to §133(a)2. Outdoor signs in tunnels or large covered areas that require illumination during daylight hours. ' §133(a)3. All outdoor signs are controlled with a dimmer that provides the ability to automatically reduce Y sign power by a minimum of 65 percent during nighttime hours. 0 Exception 1 to §133(a)3. Signs illuminated for less than one hour per day during daylight hours. 3 Exception 2 to §133(a)3. Outdoor signs in tunnels or large covered areas that require illumination during daylight hours. Exception 3 to §133(a)3. Only metal halide, high pressure sodium, cold cathode, or neon lamps used for illuminating signs or parts of signs. §133(a)4. An Electronic Message Center (EMC) having a new connected lighting power load greater than 15 kW has a control·installed capable ofreducing the lighting power by a minimum of 30 percent when 4 receiving a demand response signal that is sent out by the local utility. Exception to §133(a)4. EMC required by a health or life safety statue, ordinance, or regulation, including but not limited to exit signs and traffic signs. Field Inspector Notes: N NA / N NA 10 0 Y 9 NA NA 0 Y NW Y N Na 0 Y 0 2008 Nonresidential Compliance Forms July 2010