Laserfiche WebLink
*-SANTA <br />NAJIffi <br />Planning & Building Ageocy <br />Building Safety Divis ion <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, C492702 <br />(714) 647-5800 <br />www.santa.a na.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />soL-o1 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESTDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerinq NO to an y of the questions. D lan check shall be required. <br />Project Address:llo 8l Arcono \7- s,-"tru n't * 01 q z to5 <br />Contractor Company Name: <br />Contractor License Number: <br />YES NOAJ <br />6s <br />atr <br />doda <br />do <br />6a <br />Mu <br />Ma <br />'lho,aa s h <br />{1 A t L 5 <br />2 <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one rooflng layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Wall the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum ol 2-112 incn <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the struclural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />I certify under penalty of perjury under the laws of the State of <br />3 <br />4. <br />6 <br />7 <br />8 <br />9 <br />Mn'10 <br />Print Name <br />Phone Number <br />Email Address: 5 <br />California that the above is true,.-- <br />LJ (r <br />^-t-1-),1.q <br />--JSignature <br />Date\.1- .it2-,f <br />C. ( .T1\'iLf .LNv.\4 <br />Rev: 11/19i 2015 <br />4l I @ ,i;^a t Urn / <br />1.