Laserfiche WebLink
*-SANTA <br />NA-'ffi <br />Planning & Building Agency <br />Building Safsty Divislon <br />20 Clvic Center Plaza <br />P.O. Box 1988 (M.19) <br />Santa Ana, CA 92702 <br />(7r4) 647.s800 <br />www.santa.ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cBc 2013 <br />Solar Photovottaic (PV) Checktist for Oetached STNGLE FAMtLy RESTDENCES Onty <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certificalion section below. A copy of this form shall be attached to sach of TWO sets of plans, of <br />minimum 11" x '17" size. lf answe nq NO to anv of the ouestions. o n check shall be req u lred. <br />ProiectAddress: 2049 W HARVARD ST, SANTA ANA, CA92704 <br />Conlractor Company Name: <br />Contractor License Number <br />SOUTHWEST SUN SOLAR, INC <br />1004667 <br />YES NO Are the following applicable to the propossd project? <br />Will the PV system layout provide the required threejoot wide clear access pathways <br />per Section 605.11 of the Catifornia Fire Code, and is this shown on the roof ptan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be llush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be inslalled where ths modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will lhe PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed wilh a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum ot 2-112inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a California <br />m tr <br />2 Etr <br />Etr <br />tstr <br />Ertr <br />trtr <br />atr <br />3 <br />4 <br />5 <br />6 <br />7 <br />I tstr <br />I tsD <br />10 Etr <br />licensed professional engineer? (including project specific site plan, pV I <br />anchorage spacing, anchorage details and manufacturer's pV support in <br />ayout, <br />on.) <br />I certify under penalty of periury under the laws of the Stale of Calilorn e abovo is true: <br />pr;n1x3ms. TRANG CONG PHAM <br />phone Number: 714 582 3909 <br />Signature <br />Dale:1 <br />Emait Address: PERMIT@SOUTHWESTSUNSOLAR.COM <br />i1 <br />Rev: 8/1712015