Laserfiche WebLink
*-SANTA <br />NA <br />Itr\\l\c <br />& lutDtr[ <br />lci\0 <br />Planning & Buildlng Agoncy <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Onty <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerinq NO to anv of the questions. ol an check shall be reouired. <br />ProJ ect Address: 1037 Fairbrook Ln Santa Ana CA 92706 <br />2 <br />3 <br />Contractor Company 11"r". ParagonSun <br />Contractor License Number 1025115 C46 <br />YES NO Are the following applicable to the proposed proJect? <br />Wll the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1 1 of the California Fire Code, and is this shown on lhe roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Wll lhe PV array be flush mounted to the existing roof so that lhe plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Wll the PV system weigh maximum 4 pounds per square feet or less? <br />Vvill the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Vvill the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Wll the anchors be installed with a maximum hoflzontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Wll the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof raflers (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans VVET stamped and signed by a California <br />licensed professional engineer? (including pro.iect specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />E D <br />7 EItr <br />Eltr <br />e Eltr <br />10 EE <br />@tr <br />Eltr <br />@D <br />trtr <br />trD <br />4 <br />6 <br />8 <br />lcertify under penalty of perjury under the laws of the State of California that the above is true: <br />print Name: Erik Larsen Signature <br />phone Number: 949-5294401 <br />Email Address: lnfo@psun.us <br />Rev Al17l2O15 <br />sils. 10116120'17