Laserfiche WebLink
INSTALLATION GUIDE <br />13 DIAGRAM for HLC Series <br />DC OUTPUT 1. Maximum run(Delm J k I i : 50 pcs in series / depends on SMPS in parallel <br />SMPS R <br />lt.2' <br />£ INPUT <br />EZE <br />O 0 00 <br />O 0 00 <br />00 00 <br />OO 0O <br />2. Maximum Usage of SMPS Capacity <br />= SMPS capacity * 0.8 (80%) <br />ex) In case using 200W SMPS, <br />200W * 0.8 = 160 W for the best stability <br />Watts of LED Modules = Number of LEDs * 0.24W <br />ex) In case 200pcs of HLC3S-W, <br />200 *3* 0.24 = 144W <br />3. Pitch between modules : See the last page <br />CAUTION <br />Any actions against following contents will cause serious issues <br />such as malfunction, electric shock or burn. <br />. Do not connect directly to AC 100V / 220V <br />. Make sure that the wire connection of INPUT (AC 100V/ 220V) & OUTPUT (DC 12V) is <br />not switched. <br />. Make sure that its polarity (+, -) is connected right. (Red lined-cable : +, White cable : -) <br />. Do not over the maximum connectable numbers of module. 50EA in series. <br />. Do not cut wire or any kinds of wiring while modules are connected with live power source <br />. Avoid installation under rain or high humidity for outdoor use. <br />Installed LED Sign must be covered for outdoor use. Should be protected from rain and <br />direct ray of the sun for a long term use. It can causes crack of LED lamps. <br />For indoor use where possibly has human contacts must be covered too. <br />. Do not use in the circumstance of over 70% humidity <br />c Do not tough LED lamps with sharp objects <br />1. Make holes for water drain on the down side of channel letter for outdoor use. <br />0. Strand of modules must be capped with wire nut, compression tube or insulating tape to <br />protect from electric leakage. <br />NC LED [41]qgmi 91#01[1 Head Office : 4F Mirae B/D Amsa-dong,Kangdong-gu, Seoul, Korea <br />Factory : 16-17, Kagok-Ii, Hwado-eup, Namyangju-si, Kyunggi-Do, Korea <br />Website : www.ncled.co.kr Email to salesl@ncled.co.kr