Laserfiche WebLink
SOLARMOUNT Technical Datasheets :i: UNI RAC <br />A IllITI GROUP COMPANY <br />SolarMount Technical Datasheet <br />Pub 110818-ltd Vl.0 August 2011 <br />SolarMount Module Connection Hardware 1 <br />Bottom Up Module Clip ..1 <br />Mid Clamp ..2 <br />End Clamp <br />SolarMount Beam Connection Hardware 3 <br />L-Foot 3 <br />SolarMount Beams 4 <br />SolarMount Module Connection Hardware <br />SolarMount Bottom Up Module Clip <br />Part No. 302000C <br />Bottom Up Clip material: One of the following extruded aluminum <br />alloys: 6005-T5, 6105-T5, 6061-T6 <br />Ultimate tensile: 38ksi, Yield: 35 ksi <br />Finish: Clear Anodized <br />Bottom Up Clip weight: -0.031 lbs (14g) <br />Allowable and design loads are valid when components are <br />assembled with SolarMount series beams according to authorized <br />UNIRAC documents <br />Assemble,with one %"-20 ASTM F593 bolt, one 1/11,-20 ASTM F594 <br />serrated flange nut, and one W flat washer <br />Use anti-seize and tighten to 10 ft-lbs of torque <br />Resistance factors and safety factors are determined according to <br />part 1 section 9 of the 2005 Aluminum Design Manual and third- <br />party test results from an IAS accredited laboratory <br />Module edge must be fully supported by the beam <br />* NOTE ON WASHER: Install washer on bolt head side of assembly. <br />DO NOT install washer under serrated flange nut <br /> ' Washer <br />Bottom <br />f£\ up clip ,/Al,t (hidden.Pe <br />t310.-). <br />Beam Bolt <br />Y <br />J <br />i <br />-- - X <br />Applied Load Average Allowable Safety Design Resistance <br />Direction Ultimate Load Factor,Load Factor, <br />lbs (N)lbs (N)FS lbs (N) ® <br />Tension, Y+1566 (6967)686 (3052)2.28 1038 (4615)0.662 <br />Transverse, Xi 1128 (5019)329 (1463)3.43 497 (2213)0.441 <br />Sliding, Zi 66 (292)27 (119)2.44 41 (181)0.619 <br />Dimensions specified in inches unless noted <br />e