Laserfiche WebLink
,*,,SANTA <br />ANA-'ffi <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Cenler Plaza <br />P.O. Box '1988 (M-i9) <br />Santa Ana, CA 92702 <br />(714) 647.5800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached STNGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer lhe ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerinq NOto an v of the questions. D lan check shall be required. <br />Project Address:1322 N. OLIVE ST, SANTA ANA, CA S2706 <br />SOUTHWEST SUN SOLAR, INC <br />contractorLicenseNumber: 1004667 <br />YES NO Are the following applicable to the proposed project? <br />Will the PV system layoul provide the required three-foot wide clear access pathways <br />per Section 605.11 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV anay be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the underside of modules and lhe surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (wilh pre-drilled holes) and is this minimum embedment <br />shown on lhe plans? <br />Are ALL the structural pages of the plans WET stamped and signed by a Califomia <br />licensed professional engineer? (including project specific site plan, PV layout, <br />tr tr <br />8tr <br />Etr <br />AD <br />Etr <br />Etr <br />Etr <br />4 <br />5 <br />6 <br />7 <br />8 ED <br />o trD <br />anchorage spacing, anchorage details and manufacture/s PV suppo information.) <br />I certify under penalty of perjury under the laws of the State of California <br />pr;n1 x3mg. TRANG CONG PHAIVI <br />phone Number: 714 582 3909 <br />Signature <br />Date: <br />EmailAddress <br />Rev:8/1712015 <br />PERIU IT@SOUTHWESTSUNSOLAR,COM <br />al the bove is true: <br />Contractor Company Name: <br />10. El E