Laserfiche WebLink
,--SANTA <br />NA <br />PLITYJ[\O <br />& B[ItDi\G <br />$t\cY <br />Planning & Building Agency <br />Building Safety Division. <br />20 Civic Center Plaza ' <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-5800 <br />www-santa-ana.org <br />RES!DENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />sol-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Detached SINGLE FAMILY RESIDENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be attached to each of TWO sets of plans, of <br />minimum 11" x 17" size. lf answerinq NO to any of the questions, plan check shall be required. <br />Proj ectAddress: 405 North Gunther Pl,Santa Ana, CA92703 <br />Contractor Company Name:So lciu s <br />contractor License Number' 976336 <br />4 <br />5 <br />EA <br />fa <br />Are the following applicable to the proposed project? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1'1 of the California Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV array be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do not overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to '10" maximum between <br />the underside of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizontal spacing shown on the plans? <br />Will the minimum 5/16" lag screws be installed with a minimum of 2-112 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the structural pages of the plans stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturer's PV support information.) <br />I certify under penalty oI perjury under the laws of the State of Califo above is true: <br />print Name: Arlo H u lick Sig natu re. 844-3s7-2258Pnone NUmDer:7 l12lt8uate: <br />Email Address: sola rperm its@solcius.com <br />EAda <br />.Ea <br />aa <br />6 <br />7 <br />8 <br />rc. FJ <br />Rev: 11/19/2015 <br />YES NOt. EJ <br />,EA <br />g. .Eftr