Laserfiche WebLink
ESR-1118 <br />I1KPZ +.J Most Widely Accepted and Trusted I <br />CITY OF SANTA ANA <br />PIannR 4600ing Agency <br />5.9 The allowable compression load given in Table 3 is valid for applications where she <br />truss chord members containing the metal hinge plates, and lateral translation acr, <br />by the sheathing being installed continuously across the joint as prescribed by c <br />acceptable to the code official. Hinge plate connectors must not be used to transfer <br />perpendicularto the plane of the truss, such as for design of load transfer atjoints of <br />hing isARPx9y@d <br />3f"dE RMH1bl15S UA N CE <br />1e or by other means <br />ny loads in a direction <br />1M4"iaphragms. <br />5.10Due to the rotation provided at the joint of the Hinge Plates, the truss design must lr deled with a pin at <br />the hinge joint location. In the final installed condition, shear loads must be applie within the plane of the <br />hinge plate, at a 90-degree angle to the long axis. <br />5.11 Design of diaphragms with trusses manufactured with the Hinge Plate is outside the scope of this report. <br />5.12AIlowable design values given in Table 3 for Hinge Plate connectors are applicable when the connection is <br />made with a 1-inch (25.4 mm), or smaller, gap between the two wood members at the connection. No <br />adjustments for load duration are permitted. <br />5.13Use of the Hinge Plate is limited to prefabricated trusses. Field installation is prohibited. Compliance with <br />IBC Section 2303.4 or IRC Sections R502.11 and R802.10, as applicable, is required. <br />5.14The Alpine Truss Plates (Metal Connector Plates) described in this report are manufactured under quality <br />control programs with inspections by ICC-ES. <br />6.0 EVIDENCE SUBMITTED <br />6.1 Data in accordance with the National Design Standard for Metal Plate Connected Wood Truss Construction, <br />ANSI/TPI 1 for Alpine Wave; H and SS; and Trulox metal truss plate connectors. <br />6.2 Engineering summary of plate properties, table of design values, prepared by Alpine Engineered Products, <br />Inc. (now ITW Building Components Group, Inc.). <br />6.3 Manufacturer's descriptive literature. <br />6.4 Data in accordance with the ICC-ES Acceptance Criteria for Metal Hinge Plate Connectors for Wood <br />Trusses (AC283), approved November2015 (editorially revised January 2021) for Alpine hinge plate metal <br />connectors. <br />7.0IDENTIFICATION <br />7.1 The ICC-ES mark of conformity, electronic labeling, or the evaluation report number (ICC-ES <br />ESR-1118) along with the name, registered trademark, or registered logo of the report holder must be <br />included in the product label. <br />7.2 In addition, Wave PlatesT"' are identified by the unique double -offset slot pattern (see Figures 1 through 4). <br />H and SS plates are identified by the embossed symbol "Alpine" and either "H20" or S18" for the H and SS <br />plates, respectively. Hinge plates are identified by the grommeted hinge and the symbols "Alpine" or <br />"HP28W." <br />7.3 The report holder's contact information is the following: <br />ITW BUILDING COMPONENTS GROUP INC. <br />155 HARLEM AVENUE <br />NORTH BUILDING — 4T" FLOOR <br />GLENVIEW, ILLINOIS 60025 <br />(800) 326-4102 <br />www.alpineitw.com <br />