10278331_1317 S. MAGNOLIA - Plan (2)

Home Browse Search

Prescriptive Certificate of Compliance:CF-1R ADD Residential Additions (Page 4 of 5) Site Address: . . Enforcement Agency:Date l 3 11 +KAL AL I A HVAC SYSTEMS - HEATING Duet or Configuration Minimum Distribution Piping (Cenlral, Split, Heating Equipment Efficiency Type and Insulation Thermostat Space, Package or Type and Capacity'·21 3 (AFUE or HSPF)Location4 R-Value Type Hydronic) 41 #LL *r ft 15.1 .W 4 LL SET-4\4 Sot •-r u S Ad€- 1. Indicate Heating Type (Centra! Furnace, Wail Furnace, Heat pump, Boiler, Electric Resistance, etc.) 2. Electric resistance heating is allowed only in Component Package C, or except where electric heating is supplemental (i.e., if total capacity 12 KW or 7,000 Btu/hr electric heating is controlled by a time-limiting device not exceeding 30 minutes). See §151(b)3 exception. 3. Refer to the HERS Verification section on Page 3 and 4 ofthe CF-IR-ADD Formforadditional requirements and checkapplicable boxes, 4. Indicate Type or Location (Ducts, Hydronic in Floor, Radiators, etc.) HVAC SYSTEMS - COOLING Configuration Cooling Equipment Minimum Distribution Duet or Piping (Central, Split, Type and Capacity'·2 Efficiency Type and Insulation Thermostat Space, Package or (SEER/EER or COP)Location'R-Value Type Hydronic) 1. Indicate Cooling Type (A/C, Heat pump, Evap. Cooling, etc) 2. Refer to the HERS Verifcation section on Pages 3 and 4 of the CF-JR-ADD Formfor additional requirements and check applicable boxes. 3.Indicate Type or Location (Ducts, Hydronic in Floor, Radiators, etc.) WATER HEATING Listwater heaters and boilers for bothdomestic hot water (DHW) heaters and hydronicspace heating. Individual dwelling DHWheaters mustbe storage gas or propanefired, non-recirculating, and may not exceed 50 gallons. Ifno natural gas is connected to the building, an electric storage DHW heater iess than 50 gallons with an energy factor greater than 0.90 may be used. Hot water pipe insulationfrom the DHW heater to the kitchen(s) and on all underground hot water pipes is required in all component packages in all climate zones. External Tank Water Heater Type/Fuel Distribution Type Number In Tank Energy Factor or Insulation Type'(Standard, Recirculating)2 System Capacity (gal)Thermal Efficiency R-Value' 645 sNZ.., 1 16 6. 67 2- c S 51«2&%,1-s-ED 1. Indicate Type (Storage Gas, Heat Pump, Instantaneous, etc.) 2, Recirculatingsystems serving multiple dwelling units shelli meet the recirculation requirements of §150(n), The Prescriptive requirements do not allow the installation of a recirculating water heating systemfor single dwelling units. 3. The water heating tank and pipes shall be insulated to meet the requirements of §1500) SPECIAL FEATURES The enforcement agency should pay special attention to the Special Features specified in this checklist below. These items may require written justification and documentation and special verification. Applicable special features shall be marked with a YES and be specified within the plans. Radiant Barrier (Roof) ES O NO Required in Climate Zones 2,4, and 8-15 for additions larger than 100 ff. Slab Edge (Perimeter) Insulation O YES | *O In Climate Zone 16 under Component Package D, R-7 insulation is required. Heated Slab Insulation ¤ YES [*10 Slab edge insulation required for heated slabs in all Climate Zones. See details in Table 118-A of the standards. Raised Slab Tnsulation O YES il In Climate Zones 1, 2, 11,13,14 & 16 R-8 insulation is required, and in Climate Zones 12 & 15 R-4 insulation is required , under Component Package D. 'r' Thermal Mass - To obtain Compliance Credit for the installation of thermal mass, use the Performance Approach. Registration Number: 2008 Residential Compliance Forms Registration Date/Time:HERS Provider: A4arch 2010