10379422_3801 S. HARBOR #E - Plan (2)

Home Browse Search

6. 7. RE**Elt Y.04<,6.- ao|06¥ a../ 7@£ No. 4 11-·- 4,5nw.i Page 2 of 2 All person#reparing plans, specifications, and instruments of service for others shall sign those plans, specifications and other instruments of service for others shall sign those plans, specifications and other instruments of service and all contracts therefore. This requirement applies to both exempt and non- exempt projects. Business and Professions Code Chapter 3, Division 3, Section 5536.1(a). The applicant shall obtain clearances/approvals for the following prior to building permit ' issuance: . - Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans should be submitted to expedite the process. /13 Proof of Worker's Compensation Insurance shall be required at the time of permit issuance V Ed1 0 xit illumination and exit sign requirements in accordance with CBC Section 1011 shall be shown on the -awilps. Be specific as to the type of exit signs to be installed.9-·0€ 1 i actile(dxit signs shall be required at the following locations: / Each grade-level exterior exit door shall be identified by a tactile exit with the word "EXIT." 6 - Each exit door that leads directly to a grade-level exterior exit by means of a stairway or ramp shall be identified by a tactile exit sign with the following words as appropriate: "EXIT STAIR DOWN" "EXIT RAMP DOWN" "EXIT STAIR UP" "EXIT RAMP UP" - Each exit door that leads directly to a grade-level exterior exit by means of an exit enclosure, or an exit passageway, shall be identified by a tactile exit sign with the words "EXIT ROUTE." - Each exit access door from an interior room or area to a corridor or hallway, which is required to have a visual exit sign, shall be identified by a tactile exit sign with the words "EXIT ROUTE." - Each exit door through a horizontal exit shall be identified by a sign with the words "TO EXIT." BMAilt nA,k'll If a waircroases or adjoins a vehicular way, and the walking surfaces are not separated by curbs, ' railings or other elements between the pedestrian areas and vehicular areas, the boundary between the ageas shall be defined by a continuous detectable warning which is 36" wide, complying with the CBC Section 1133B.8.5. Detectable Warning Product Approval. Only approved Division of the State Architect, Access Complianc42§#*CD'pproved detectable warning products and directional surfaces shall be installed in accordance vVifFECEIC Section 1 132.#.- 36*27 4-ck.0* 7944 J si-u_ 414 56+7,4 .711 J show how partition wall is pported faterally Ut the top and bottom. 1-1 1 -13 width of the openings shall be minimum 36" wide. i n Al e ase fill out attached handicap compliance form. S k.v niw ·tr•. cAV· D*-6 1 i