Laserfiche WebLink
L L <br />L L <br />L L <br />ALL NOTES ARE TYPICAL THROUGHOUT: <br />1. REFER TO GENERAL NOTES IA-G1 AND IA-G2 FOR ADDITIONAL INFORMATION. <br />2. VERIFY EXISTING CONDITIONS AND NOTIFY H. HENDY ASSOCIATES OF ANY DISCREPANCIES. <br />3. WORK SHALL COMPLY FULLY WITH ALL APPLICABLE NATIONAL, STATE AND LOCAL CODES. <br />4. CONTRACTOR SHALL VERIFY CONDITION OF SLAB AND PATCH/REPAIR TO SMOOTH AND LEVEL AS <br />REQUIRED TO RECEIVE FLOOR FINISHES. PATCH AND FILL ALL ABANDONED FLOOR CORES PRIOR TO <br />INSTALLATION OF FINISHES. <br />5. DEMOLISH PARTITIONS, DOOR ASSEMBLIES AND SIDELIGHTS AS SHOWN ON PLAN. PATCH AND REPAIR <br />ADJACENT CONSTRUCTION AS REQUIRED. EXISTING COLUMN FURRING TO REMAIN. TERMINATE <br />RELATED ELECTRICAL BACK TO POINT OF ORIGIN. <br />6. AT PARTITIONS BEING DEMOLISHED, ALL EXISTING POWER/TELE-DATA RECEPTACLES TO BE REMOVED. <br />DISCONNECT AND REMOVE ALL HOMERUN CONDUITS AND CONDUCTORS FROM RECEPTACLES BACK TO <br />POINT OF ORIGIN AS REQUIRED. <br />7. REMOVE ALL FLOORING, BASE, WALLCOVERING, WHITEBOARDS & TACKBOARDS, U.O.N. SCRAPE FLOOR <br />AND CLEAN/PREP FOR NEW FUTURE FLOOR FINISHES. <br />8. REMOVE EXISTING TENANT AND EGRESS SIGNAGE AND ANY MISC. SCREWS/NAILS IN WALLS. PATCH <br />WALL AND PREP FOR NEW FINISHES. <br />9. REMOVE/REPLACE ALL OUTLETS THAT DO NOT MEET CODE OR CURRENT BUILDING STANDARD <br />STYLE/FINISH. CONTRACTOR TO VERIFY IN FIELD AND PROVIDE COUNTS AND LOCATIONS. <br />10. REMOVE EXISTING POWER/TELE/DATA RECEPTACLES AND WALL FEEDS AS INDICATED BY "D", DO NOT <br />BLANK PLATE. REMOVE ALL UNUSED CABLING/CONDUITS IN WALLS, FLOORS, AND ABOVE CEILING IN <br />THEIR ENTIRETY. COORDINATE WITH POWER & SIGNAL PLANS TO REUSE/MODIFY EXISTING WHEN <br />AVAILABLE. REMOVE ALL BLANK PLATES AND ALL ASSOCIATED LOW VOLTAGE CABLING THROUGHOUT <br />WHERE INDICATED. <br />11. EXISTING WINDOW COVERINGS AT ALL PERIMETER WINDOWS TO REMAIN. CLEAN AND REPAIR FOR LIKE- <br />NEW APPEARANCE. <br />DEMOLITION NOTES <br />EXISTING PARTITION TO REMAIN, PROTECT IN PLACE <br />DEMOLISH EXISTING PARTITION <br />REMOVE EXISTING MILLWORK <br />REMOVE DOOR ASSEMBLY, SAVE FOR POTENTIAL REUSE <br />DEMOLISH SIDELIGHT OR GLAZING. <br />AREA NOT IN CONTRACT <br />LEGEND <br />1 <br />A <br />B <br />C <br />D <br />C.6 <br />C.5 <br />2 3 4 5 6 <br />101 <br />LOBBY <br />101A <br />RECEPTION <br />102 <br />OFFICE <br />105 <br />MEN <br />106 <br />JAN <br />401 <br />SOUTH STAIR402 <br />OFFICE <br />403 <br />OFFICE <br />404 <br />OFFICE <br />405 <br />OFFICE 408 <br />OFFICE <br />107 <br />OFFICE <br />108 <br />OFFICE <br />109 <br />OFFICE <br />112 <br />OFFICE <br />113 <br />IT <br />114 <br />OFFICE <br />115 <br />OFFICE <br />118 <br />BREAK ROOM <br />121 <br />LOBBY <br />119 <br />MEN <br />120 <br />WOMEN 120A <br />NORTH STAIR <br />126 <br />HALLWAY <br />122 <br />OFFICE <br />124 <br />OFFICE <br />125 <br />CONF. <br />307 <br />ELECTRICAL <br />311 <br />PACKAGING <br />104 <br />WOMEN <br />103 <br />MECH <br />C <br />A <br />B <br />M <br />M M M <br />D <br />D <br />D <br />D <br />FFF <br />C <br />J K <br />J <br />L <br />J <br />54 <br />' <br /> <br />- <br /> <br />4 <br />" <br />22 <br />' <br /> <br />- <br /> <br />1 <br />" <br />28' - 7"41' - 5"6' - 2" <br />6' <br /> <br />- <br /> <br />5 <br />" <br />M <br />M M M <br />M M <br />M <br />M <br />M <br />M M <br />M <br />MM <br />M <br />M <br />M <br />M <br />1 <br />IA-5.2‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒ <br />2 <br />IA-5.2‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒ <br />3 <br />IA-5.2‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒ <br />NNN <br />P <br />P <br />6 <br />IA-5.2‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒‒ <br />ROUGHEN AND REDUCE EXISTING CONCRETE SURFACE IN THIS AREA TO RECEIVE NEW SELF-LEVELING <br />COMPOUND. GRIND ALL DIFFERENCES IN HEIGHT GREATER THAN .2 INCHES AND FILL ALL GAPS GREATER <br />THAN .2 INCHES. <br />A <br />DEMOLITION PLAN KEY NOTES <br />SAWCUT AND REMOVE EXISTING SLAB TO ACCOMODATE NEW PLUMBING.B <br />EXISTING MILLWORK TO BE REMOVED INCLUDING EXISTING PLUMBING FIXTURES. PROTECT ALL SUPPLY AND <br />DRAIN LINES IN PLACE. <br />C <br />EXISTING WINDOW TO BE REMOVEDD <br />EXISTING COILING DOOR TO BE REMOVEDE <br />EXISTING ONE WAY REFLECTIVE GLAZING TO BE REMOVED. PROTECT EXISTING FRAME AND PREPARE TO <br />RECEIVE NEW GLAZING. <br />F <br />REMOVE DECALS AT WINDOWSG <br />EXISTING DUCTWORK TO BE RELOCATED AWAY FROM PALLET RACK AREA.H <br />EXISTING EXISTING MILLWORK TO BE REMOVEDJ <br />EXISTING PLATFORM TO BE REMOVEDK <br />EXISTING SLAB TO BE SAWCUT AND REMOVED TO ACCOMODATE TRENCHINGL <br />REMOVE ALL CARPET, FLOORING, AND WALLBASE THROUGHOUTM <br />EXISTING WINDOW AND FRAME TO BE REMOVED AND RE-INSTALLED IN NEW WALL.N <br />EXISTING COILING DOOR AND TRACK TO BE REMOVED.P <br />NORTH <br />HHENDY.COM <br />T (949) 851-3080 <br />4770 Campus Dr., Suite 100 <br />Newport Beach, CA 92660 <br />H ndy <br />ISSUES AND REVISIONS <br />JOB NUMBER <br />SCALE <br />PROJECT <br />TEAM <br />All specifications, drawings, concepts, designs, arrangements, intellectual and written material represented herein constitute <br />unique and unpublished work of H. Hendy Associates and may not be copied, used by or disclosed to others without written <br />consent of H. Hendy Associates. <br /> 2023 H.HendyAssociatesc <br />DATE <br />1/8" = 1'-0" <br />04463.0000.24 <br />3080 S. HARBOR BLVD. <br />SANTA ANA, CA 92704 <br />LEVEL 1 DEMOLITION PLAN <br />IA-1.1D <br />MCGUFF <br />AB/CD <br />NO. DESCRIPTION DATE <br />PLAN CHECK SUBMITTAL 3/17/25