Laserfiche WebLink
Round 1 Bowling and Amusement 12/09/2024 Paradigm Design <br />Main Place Mall Expansion Grand Rapids, MI <br />Santa Ana, California <br />Project #2309147GR <br />COLD-FORMED METAL FRAMING 05 4000 - 11 <br />1.Cut framing members by sawing or shearing; do not torch cut. <br />2.Fasten cold-formed steel framing members by welding, screw fastening, clinch fastening, or <br />riveting. Wire tying of framing members is not permitted. <br />a.Comply with AWS D1.3/D1.3M requirements and procedures for welding, appearance and <br />quality of welds, and methods used in correcting welding work. <br />b.Locate mechanical fasteners, install according to Shop Drawings, and comply with <br />requirements for spacing, edge distances, and screw penetration. <br />E.Install framing members in one-piece lengths unless splice connections are indicated for track or tension <br />members. <br />F.Install temporary bracing and supports to secure framing and support loads equal to those for which <br />structure was designed. Maintain braces and supports in place, undisturbed, until entire integrated <br />supporting structure has been completed and permanent connections to framing are secured. <br />G.Do not bridge building expansion joints with cold-formed steel framing. Independently frame both sides of <br />joints. <br />H.Install insulation, specified in Section 07 2100 "Thermal Insulation," in framing-assembly members, such as <br />headers, sills, boxed joists, and multiple studs at openings, that are inaccessible on completion of framing <br />work. <br />I.Fasten hole-reinforcing plate over web penetrations that exceed size of manufacturer's approved or standard <br />punched openings. <br />3.4 INSTALLATION OF LOAD-BEARING WALL FRAMING <br />A.Install continuous top and bottom tracks sized to match studs. Align tracks accurately and securely anchor <br />at corners and ends, and at spacings as follows: <br />1.Anchor Spacing: As shown on Shop Drawings. <br />B.Squarely seat studs against top and bottom tracks, with gap not exceeding 1/8 inch between the end of wall- <br />framing member and the web of track. <br />1.Fasten both flanges of studs to top and bottom tracks. <br />2.Space studs as follows: <br />a.Stud Spacing: As indicated on Drawings. <br />C.Set studs plumb, except as needed for diagonal bracing or required for nonplumb walls or warped surfaces <br />and similar configurations. <br />D.Align studs vertically where floor framing interrupts wall-framing continuity. Where studs cannot be <br />aligned, continuously reinforce track to transfer loads.