Laserfiche WebLink
Round 1 Bowling and Amusement 12/09/2024 Paradigm Design <br />Main Place Mall Expansion Grand Rapids, MI <br />Santa Ana, California <br />Project #2309147GR <br />GLAZING 08 8000 - 5 <br />ed. 2024-02-20 <br />2.IGMA Publication for Insulating Glass: SIGMA TM-3000, "North American Glazing <br />Guidelines for Sealed Insulating Glass Units for Commercial and Residential Use." <br />B.Safety Glazing Labeling: Where safety glazing is indicated, permanently mark glazing with <br />certification label of the SGCC or another certification agency acceptable to authorities having <br />jurisdiction. Label shall indicate manufacturer's name, type of glass, thickness, and safety glazing <br />standard with which glass complies. <br />C.Insulating-Glass Certification Program: Permanently marked either on spacers or on at least one <br />component lite of units with appropriate certification label of the IGCC. <br />D.Thickness: Where glass thickness is indicated, it is a minimum. Provide glass that complies with <br />performance requirements and is not less than thickness indicated. <br />1.Minimum Glass Thickness for Exterior Lites: 6 mm. <br />2.Thickness of Tinted Glass: Provide same thickness for each tint color indicated throughout <br />Project. <br />E.Strength: Where annealed float glass is indicated, provide annealed float glass, heat-strengthened float <br />glass, or fully tempered float glass as needed to comply with "Performance Requirements" Article. <br />Where heat-strengthened float glass is indicated, provide heat-strengthened float glass or fully <br />tempered float glass as needed to comply with "Performance Requirements" Article. Where fully <br />tempered float glass is indicated, provide fully tempered float glass. <br />2.4 GLASS PRODUCTS <br />A.Clear Annealed Float Glass: ASTM C1036, Type I, Class 1 (clear), Quality-Q3. <br />B.Tinted Annealed Float Glass: ASTM C1036, Type I, Class 2 (tinted), Quality-Q3. <br />C.Fully Tempered Float Glass: ASTM C1048, Kind FT (fully tempered), Condition A (uncoated) unless <br />otherwise indicated, Type I, Class 1 (clear) or Class 2 (tinted) as indicated, Quality-Q3. <br />1.Fabrication Process: By horizontal (roller-hearth) process with roll-wave distortion parallel to <br />bottom edge of glass as installed unless otherwise indicated. <br />D.Heat-Strengthened Float Glass: ASTM C1048, Kind HS (heat strengthened), Type I, Condition A <br />(uncoated) unless otherwise indicated, Type I, Class 1 (clear) or Class 2 (tinted) as indicated, Quality- <br />Q3. <br />1.Fabrication Process: By horizontal (roller-hearth) process with roll-wave distortion parallel to <br />bottom edge of glass as installed unless otherwise indicated. <br />E.Low-E-Coated Vision Glass: ASTM C1376.