Laserfiche WebLink
ESR-3699 Page 8 of 18 <br /> <br /> <br />5.17 The design of anchor groups in accordance with ACI 318 (-19 and -14) Chapter 17 or ACI 318-11 Appendix <br />D, as applicable, is valid for screw anchors with a thread length of at least 80 percent of the nominal <br />embedment depth. Anchors with a thread length less than 80 percent of the nominal embedment depth <br />shall be designed as single anchors. <br />5.18 Use of anchors must be limited to dry, interior locations. <br />5.19 Special inspection must be provided in accordance with Section 4.4 of the report. <br />5.20 Anchors are manufactured in the U.S.A. under an approved quality-control program with inspections by <br />ICC-ES. <br />6.0 EVIDENCE SUBMITTED <br />Data in accordance with the ICC-ES Acceptance Criteria for Mechanical Anchors in Concrete Elements (AC193), <br />dated October 2017 (editorially revised December 2020); and quality-control documentation. <br />7.0 IDENTIFICATION <br />7.1 The Tapcon+ Screw Anchors and SAMMYS Anchors are identified by packaging labeled with the <br />manufacturer’s name (ITW Red Head, ITW Buildex, or ITW Brands), contact information, anchor name, <br />anchor size, and evaluation report number (ESR-3699). The Red Head logo or “BX” logo, and a length <br />identification code letter are stamped on the head of each anchor. See the length identification system <br />illustrated in Figure 2 of this report. <br />7.2 The report holder’s contact information is the following: <br />ITW RED HEAD <br />ITW BUILDEX <br />155 HARLEM AVENUE <br />GLENVIEW, ILLINOIS 60025 <br />(800) 848-5611 <br />www.itw-redhead.com <br />techsupport@itwccna.com <br />7.3 The Additional Listee’s contact information is the following: <br />ITW BRANDS <br />155 HARLEM AVENUE <br />GLENVIEW, ILLINOIS 60025 <br />(877) 489-2726 <br />www.itwbrands.com <br /> <br /> <br />TABLE A—PRODUCT IDENTIFICATION CROSS REFERENCE BY MANUFACTURER <br />PRODUCT REFERENCE PER <br />ICC-ES ESR-3699 ITW RED HEAD ITW BUILDEX ITW BRANDS <br />1/4" SAMMYS for Vertical Rod Not applicable 1/4" SAMMYS for Vertical <br />Rod Part No. CCST 516 Not applicable <br />1/4" SAMMYS for Horizontal Rod Not applicable <br />1/4" SAMMYS for <br />Horizontal Rod Part No. <br />SW-CCST 516 <br />Not applicable <br />1/4" Tapcon+ Anchor 1/4" Tapcon+ Anchor Not applicable Buildex 5/16" Tapcon+ <br />Anchor <br />3/8" Tapcon+ Anchor 3/8" Tapcon+ Anchor Not applicable Buildex 3/8" Tapcon+ <br />Anchor <br />1/2" Tapcon+ Anchor 1/2" Tapcon+ Anchor Not applicable Buildex 1/2" Tapcon+ <br />Anchor <br /> <br />