Laserfiche WebLink
ESR-3699 Page 10 of 18 <br /> <br /> <br /> INSTALLATION INSTRUCTIONS FOR TAPCON+ SCREW ANCHORS <br /> <br /> <br /> <br />ANCHOR DIAMETER <br />(inch) <br />ANSI DRILL <br />BIT <br />DIAMETER <br />(inch)1 <br />ANCHOR HEAD <br />(SOCKET SIZE) <br />DIAMETER <br />(inch) <br />ANCHOR <br />HEAD <br />HEIGHT <br />(inch) <br />WASHER <br />DIAMETER <br />(inch) <br />MANUAL <br />WRENCH <br />MAX <br />TORQUE2 <br />IMPACT <br />WRENCH <br />MAX <br />TORQUE <br />RATING <br />1/4 (ITW Red Head Anchor) 1/4 3/8 0.24 1/2 20 FT LBS 115 FT LBS <br />5/16 (ITW Brands Anchor) 1/4 3/8 0.24 1/2 20 FT LBS 115 FT LBS <br />3/8 3/8 9/16 0.35 13/16 50 FT LBS 200 FT LBS <br />1/2 1/2 3/4 0.45 1 70 FT LBS 345 FT LBS <br />1 A 1/4-inch Tapcon+ drill bit may also be used for installation of the 1/4-inch anchor. <br />2 For manual installation, use a torque wrench to verify that the maximum installation torque has not been exceeded. <br /> <br /> <br /> <br /> <br />Installation Steps for Concrete <br /> <br /> <br />1. Using a 1/4-inch Tapcon+ drill bit, drill a hole at least 1/4-inch deeper than anchor embedment. <br />2. Clean hole with compressed air or vacuum to remove any excess dust/debris. <br />3. Insert appropriate torque-limiting nut driver into the drill. See chart below. <br />4. Insert the anchor into the nut driver, position the anchor into hole and tighten anchor until nut driver spins <br />free on cap of anchor. <br />Anchor Model Torque-Limiting <br />Nut Driver <br />(Color) <br />Installation <br />Orientation <br />Rod Size <br />(inch) <br />CCST 516 #14 (Black) Vertical 3/8 <br />SW-CCST 516 #14 SW (Red) Horizontal 3/8 <br />FIGURE 4—INSTALLATION INSTRUCTIONS FOR TAPCON+ SCREW ANCHOR <br />AND SAMMYS THREADED ROD ANCHOR <br /> <br />