Laserfiche WebLink
www.hilti.com <br />Hilti PROFIS Engineering 3.0.88 <br />Input data and results must be checked for conformity with the existing conditions and for plausibility! <br />PROFIS Engineering ( c ) 2003-2023 Hilti AG, FL-9494 Schaan Hilti is a registered Trademark of Hilti AG, Schaan <br />9 <br />Company: <br />Address: <br />Phone I Fax: <br />Design: <br />Fastening point: <br /> | <br />Distribution Panel <br />Page: <br />Specifier: <br />E-Mail: <br />Date: <br />9 <br />10/10/2023 <br />8 Remarks; Your Cooperation Duties <br />• Any and all information and data contained in the Software concern solely the use of Hilti products and are based on the principles, formulas <br /> and security regulations in accordance with Hilti's technical directions and operating, mounting and assembly instructions, etc., that must be <br /> strictly complied with by the user. All figures contained therein are average figures, and therefore use-specific tests are to be conducted prior <br /> to using the relevant Hilti product. The results of the calculations carried out by means of the Software are based essentially on the data you <br /> put in. Therefore, you bear the sole responsibility for the absence of errors, the completeness and the relevance of the data to be put in by <br /> you. Moreover, you bear sole responsibility for having the results of the calculation checked and cleared by an expert, particularly with <br /> regard to compliance with applicable norms and permits, prior to using them for your specific facility. The Software serves only as an aid to <br /> interpret norms and permits without any guarantee as to the absence of errors, the correctness and the relevance of the results or suitability <br /> for a specific application. <br />• You must take all necessary and reasonable steps to prevent or limit damage caused by the Software. In particular, you must arrange for <br /> the regular backup of programs and data and, if applicable, carry out the updates of the Software offered by Hilti on a regular basis. If you do <br /> not use the AutoUpdate function of the Software, you must ensure that you are using the current and thus up-to-date version of the Software <br /> in each case by carrying out manual updates via the Hilti Website. Hilti will not be liable for consequences, such as the recovery of lost or <br /> damaged data or programs, arising from a culpable breach of duty by you.