2350 S Pullman St-Phase I-DEF 1-Concrete Foundation Underpinning - Plan

Home Browse Search

1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. GENERAL NOTES DIMENSIONS GIVEN ARE PER THE DRAWING LEGEND AND ARE NOT TO BE SCALED. IF DIMENSIONS NEEDED ARE NOT DETERMINABLE IN THE DOCUMENTS, CONTACT THE ARCHITECT/ENGINEER. DIMENSIONS ARE GIVEN FROM FINISHED FACE TO FINISHED FACE, UNLESS NOTED OTHERWISE. THE CONTRACTOR SHALL VISIT THE SITE PRIOR TO CONSTRUCTION TO BECOME FAMILIAR WITH EXISTING CONDITIONS THAT MAY AFFECT THE WORK. THE CONTRACTOR SHALL NOTIFY THE ARCHITECT/ENGINEER IN WRITING IF ANY DISCREPANCIES ARE FOUND IN THE DOCUMENTS DURING THE BIDDING PROCESS PRIOR TO SUBMISSION OF THE BIDS AND PRIOR TO BEGINNING WORK ON THE PARTICULAR PART OF THE PROJECT. THIS INCLUDES BUT IS NOT LIMITED TO DIMENSIONS, FLOOR HEIGHTS, STEEL OR WALL HEIGHTS, MASONRY OPENING SIZES AND LOCATIONS, AND COLUMN LOCATIONS AND SIMILAR CONDITIONS. THE CONTRACTOR SHALL VERIFY ALL EXISTING DIMENSIONS AND BUILDING CONDITIONS WHERE NEW WORK IS DEPENDENT OR TYING INTO, WHETHER INDICATED OR NOT ON THE DRAWINGS. ANY DISCREPANCIES OR EXISTING CONDITIONS THAT WOULD AFFECT THE WORK SHALL BE BROUGHT TO THE ATTENTION OF THE ARCHITECT/ENGINEER IN WRITING FOR RESOLUTION DURING THE BIDDING PROCESS PRIOR TO SUBMISSION OF THE BIDS AND PRIOR TO BEGINNING WORK ON THE PARTICULAR PART OF THE PROJECT. THE CONTRACTOR SHALL PROVIDE PHOTOS, DIAGRAMS OR SKETCHES TO EXPLAIN THE SITUATION AND OFFER FEASIBLE SOLUTIONS. THE CONTRACTOR SHALL COMPLY WITH ALL APPLICABLE LAWFUL ORDERS AND REGULATIONS OF GOVERNING AUTHORITIES. THE CONTRACTOR IS RESPONSIBLE FOR OBTAINING ALL REQUIRED BUILDING PERMITS AND FIELD INSPECTIONS AS DIRECTED BY THE LOCAL BUILDING AUTHORITY. ANY AND ALL REMEDIAL WORK TO CORRECT INSPECTION DEFICIENCIES SHALL BE BORNE BY THE CONTRACTOR UNLESS A DOCUMENT ERROR WAS AT CAUSE. AT THE CLOSE OF THE PROJECT THE CONTRACTOR SHALL OBTAIN A CERTIFICATE OF OCCUPANCY FOR THE OWNER. EACH CONTRACTOR OR TRADE SHALL FAMILIARIZE THEMSELVES WITH THE WORK OF OTHER TRADES AND COORDINATE BETWEEN EACH OTHER AS NEEDED SO AS TO AVOID CONFLICTS. ANY FINISHED WORK THAT HAS TO BE REMOVED IN ORDER TO LATER INSTALL WORK OF OTHERS WILL BE THE RESPONSIBILITY OF THE CONTRACTOR(S) WHO FAILED TO COORDINATE THE WORK WITH OTHERS. UNLESS NOTED OR INDICATED OTHERWISE, THE GENERAL BUILDING CONTRACTOR SHALL PROVIDE FOR ALL STRUCTURAL AND MISCELLANEOUS STEEL, INCLUDING SUPPORTS FOR ROOF TOP MOUNTED EQUIPMENT, MASONRY OPENING LINTELS, AND FLOOR AND ROOF OPENINGS. THE THERMAL INSULATION ENVELOPE SHALL BE INSTALLED AS CONTINUOUS IN ROOF AND WALLS. ANY GAPS SHALL BE FILLED WITH INSULATION SUCH AS FOAMED-IN-PLACE INSULATION. REFER TO MECHANICAL, PLUMBING, ELECTRICAL AND REFRIGERATION PLANS FOR EQUIPMENT THAT MAY NOT BE INDICATED ON THE ARCHITECTURAL/ENGINEERING PLANS AND WOULD AFFECT THE CONSTRUCTION OF BUILDING COMPONENTS. COORDINATE WITH OTHER TRADES TO PROVIDE CONSTRUCTION NEEDED. PROVIDE BOND BREAKER TAPE OR COATING WHERE DISSIMILAR METALS MEET. PROVIDE BLOCKING, STRAPPING, AND SUPPORT WITHIN PARTITIONS, WALLS, OR CEILINGS TO ATTACH SURFACE MOUNTED ITEMS AS NEEDED. CONTRACTOR TO COORDINATE WORK WITH OWNER ’S MAINTENANCE STAFF TO MINIMIZE DISRUPTION. CONTRACTOR TO MAINTAIN A SAFE AND CLEAN WORK AREA DURING PROJECT DURATION. OWNER ’S MAINTENANCE REPRESENTATIVE TO DO A WALK THROUGH WITH CONTRACTOR AT PROJECT COMPLETION TO SIGN EACH WORK AREA OFF AS COMPLETE AND TO ENSURE THAT “GOOD HOUSEKEEPING PRACTICES HAVE BEEN MET ”. SEE MECHANICAL DRAWINGS FOR FLOOR DRAINS AND FLOOR SLOPES TO DRAINS. ALL EXISTING EXTERIOR SURFACES THAT ARE BECOMING INTERIOR AS A RESULT OF NEW CONSTRUCTION MUST BE CLEANED AND FREE OF DIRT/ MOLD/ RESIDUE. THESE WALLS ARE TO BE INSPECTED FOR DAMAGE, WHICH MUST BE REPAIRED. IMP CAULKED JOINTS AT EXISTING WALLS MUST BE INSPECTED AND RE-CAULKED IF NECESSARY. EXISTING CMU WALLS WILL RECEIVE NEW CMU WALL PAINT FINISH. RE-PAINT EXISTING TRIM IF TRIM FINISH IS DAMAGED. THIS PROJECT IS NOT TO BE INSURED BY FACTORY MUTUAL GLOBAL EXIST COURTYARD 4 B-200-1 1714 SF DOCK ADDITION 131 TEMPORARY TENT 133 N3 N1 N4 N5 N6 N2 NA NAANB NC NDNENF 2 B-500-1 TEMPORARY TRASH DUMPSTER LOCATION (DURING CONSTRUCTION). PUSH OUT INTO ALLEY WITH FORK TRUCK AT PICKUP. 15' - 6" EXISTING COOLER 102 EXISTING PACKAGING 104 EXISTING FREEZER 103 EXISTING ELECTRICAL ROOM 101 B-401-1 A B-401-1 B TO TOP OF EXIST. CONC. PANEL CONCRETE COATING B TO T O P O F E X I S T C O N C . P A N E L CO N C R E T E C O A T I N G A TEMPORARY TRUCK POSITION RELOCATED COMPACTOR B-200-1 6 1 - DRAWN BY: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CHECKED BY: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SHEET ISSUE DATE: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SHEET NUMBER THE INFORMATION CONTAINED ON THIS AND ANY RELATED DOCUMENT SHALL NOT BE USED FOR ANY PURPOSE OTHER THAN THE CONVEYANCE OF INFORMATION FOR THE STATED CLIENT AND PROJECT WITHOUT THE EXPRESS WRITTEN CONSENT OF THE ENGINEER. ANY INFORMATION TRANSFERRED OR UTILIZED IN AUTOCAD .DWG FORMAT SHALL BE USED FOR REFERENCE ONLY WEBBER/SMITH Associates, Inc. 20 Wright Avenue Lititz, Pennsylvania 17543 Phone: 717.625.4140 Email:info@webbersmith.com SHEET TITLE: FOR DRAWING STATUS FINAL PROJECT NUMBER www.webbersmith.com SEAL B-100-1 RBF EJE 04/02/2024 OVERALL FLOOR PLAN 2350 PULLMAN ASPIRE BAKERY 2350 PULLMAN STREET SANTA ANA, CA 92705 CA 5387 © 2024 WEBBER/SMITH Associates, Inc., All Rights Reserved 2350 PULLMAN,LLC 3/32" = 1'-0"B-100-1 1 OVERALL FLOOR PLAN 1 2 EXISTING FACILITY NO WORK KEY PLAN REFERENCE NORTH TRUE NORTH NO.DATE DESCRIPTION A 04/02/2024 ISSUED FOR PERMIT AND CONSTRUCTION B 11/05/24 BULLETIN #3 - PHASE 1 B 01- REGISTERED PROFESSIONAL ENGINEER67268RICHARD MAURICE THIBEAULT STATE OF CALIFORNIACIVIL 11/5/24 2350 S Pullman St - Phase I3/4/2025