505 E Central Ave #B - DEF 1 - Plan

Home Browse Search

CITY OF SANTA ANA SPECIFICATIONS PROJECT NO.: XX-XXXX PROJECT TITLE 70 minimum of two rivets installed per sign. However, signs greater than 45 inches in height shall have three rivets per sign installed in the top, middle and bottom of the sign. Each signpost shall utilize a minimum of two rivets to attach the sign post to the sign post anchor assembly. The fourth paragraph of Section 56-4.02E, “Sign Panel Fastening Hardware,” of the Caltrans Standard Specifications shall be deleted. C. INSTALLATION AND REMOVAL Section 56-4.03, “Construction,” of the Caltrans Standard Specifications shall be deleted and replaced with the following: The Contractor shall install new and relocate existing signs as noted on the plans, shall protect-in-place existing signs, posts and parking meters which are not to be removed, and shall replace any of these signs which are damaged during construction. Sign to be mounted on streetlight or traffic signal poles shall be installed using the strap and saddle bracket method as shown on Caltrans Standard Plan RS-4. Sign panels on traffic signal mast arms shall be installed per Caltrans Standard Plan ES-7N, Detail U. Signs mounted on streetlight poles (electroliers) shall be mounted so as not to cover electrolier identification tags. Posts shall be installed in driven post anchors per the manufacturer’s specifications. New signs shall be installed on 10 foot posts, except a longer post shall be used if necessary to maintain a 7 foot vertical clearance from the bottom of the lowest sign to the top of the surrounding surface in pedestrian areas. Sign posts shall be installed a minimum of 6 feet from power poles, fire hydrants, and other obstructions. Sign posts shall be installed per City of Santa Ana Standard Plan No 1504. All signs to be salvaged, as called for on the plans, shall be become property of the contractor. All posts driven sign post anchors shall be completely removed and the sign post anchor assembly hole backfilled with clean fill dirt to match the existing surrounding grade (non-paved areas only). Driven sign post anchors in sidewalk or pavement areas shall be completely removed and backfilled with grout to the level of the surrounding grade. Sign posts with foundations in parkway area shall be completely removed and backfilled with clean fill dirt to match the grade of the surrounding area. Sign posts located within sidewalk or other paved areas, shall core drill the sidewalk and remove the sign post to below sidewalk or paving then backfilled with concrete or paving material to match the existing. 505 E Central Ave #B11/6/2024