Laserfiche WebLink
ST. BARBARA CATHOLIC SCHOOL TASK 2 75-24272-01 <br />DIOCESE OF ORANGE SEPTEMBER 12TH, 2024 <br />SANTA ANA, CA BID & PERMIT SET <br /> <br />PRODUCT REQUIREMENTS 016000 - 4 <br />1. Manufacturer's Warranty: Written warranty furnished by individual manufacturer for a <br />particular product and specifically endorsed by manufacturer to Owner. <br />2. Special Warranty: Written warranty required by the Contract Documents to provide <br />specific rights for Owner. <br />B. Special Warranties: Prepare a written document that contains appropriate terms and <br />identification, ready for execution. <br />1. Manufacturer's Standard Form: Modified to include Project-specific information and <br />properly executed. <br />2. Specified Form: When specified forms are included with the Specifications, prepare a <br />written document using indicated form properly executed. <br />3. See other Sections for specific content requirements and particular requirements for <br />submitting special warranties. <br />C. Submittal Time: Comply with requirements in Section 017700 "Closeout Procedures." <br />PART 2 - PRODUCTS <br />2.1 PRODUCT SELECTION PROCEDURES <br />A. General Product Requirements: Provide products that comply with the Contract Documents, are <br />undamaged and, unless otherwise indicated, are new at time of installation. <br />1. Provide products complete with accessories, trim, finish, fasteners, and other items <br />needed for a complete installation and indicated use and effect. <br />2. Standard Products: If available, and unless custom products or nonstandard options are <br />specified, provide standard products of types that have been produced and used <br />successfully in similar situations on other projects. <br />3. Owner reserves the right to limit selection to products with warranties meeting <br />requirements of the Contract Documents. <br />4. Where products are accompanied by the term "as selected," Architect will make <br />selection. <br />5. Descriptive, performance, and reference standard requirements in the Specifications <br />establish salient characteristics of products. <br />B. Product Selection Procedures: <br />1. Sole Product: Where Specifications name a single manufacturer and product, provide the <br />named product that complies with requirements. Comparable products or substitutions for <br />Contractor's convenience will not be considered. <br />a. Sole product may be indicated by the phrase: "Subject to compliance with <br />requirements, provide the following: …" <br />2. Sole Manufacturer/Source: Where Specifications name a single manufacturer or source, <br />provide a product by the named manufacturer or source that complies with requirements.