Laserfiche WebLink
I <br />I <br />n <br />rt I <br />-(fu7 nrr <br />(35.7" ) <br />L <br />t <br />l, <br />I il I <br />I I -t <br />I <br />I <br />I <br />I <br />I <br />I <br />aI <br />L l <br />1 ) <br />II <br />7{.1 nun <br />(29,3")I 206 mnr <br />(6.t "1 <br />INSI-ALL WALL MOUNT: <br />1. MARK THE LOCATION ON THE WALL FOR THE HOLES. <br />2. DRILL HOLES FOR FASTENERS IN THE WALL. <br />3. DRIVE THE FASTENERS THROUGH THE MOUNTING BRACKET INTO THE HOLES.. RECOMMENDED DIAMETER: 10MM(0.4") MlN.r RECOMMENDED LENGTH : 76MM(3") MlN.o RECOMMENDED MATERIAL: STAINLESS STEEL (8.8T). MINIMUM FASTENER COUNT : 4(AREA1) / 2(AREA2) / 4(AREA3) / 2(AREA4) - VERTICALLYr MINIMUM FASTENER CLEARANCE : AT LEAST 250MM(10) Ex. BETWEEN AREA 1'S LAST FASTENER AND AREA 2'S <br />FIRST FASTENER, <br />INSTALL BATTERY PACK:1. FtX THE L|FT HANDLES TO THE HEX-SOCKET SCREWS ON THE REAR (MARKED POS|TION) OF BOTH LEFT AND RTGHT <br />SIDES. <br />2, MOUNT THE WALL BRACKET TO A WALL. TIGHTEN THE SCREWS, ENSURING THAT THEY ARE HORIZONTALLY DRIVEN <br />INTO THE WALL. (MUST BE INSTALLED vvlTH RECOMMENDED CLEARANCES(72OMM[29]) ON THE EDGE OF THE WALL <br />BRACKET AS SHOWN IN THE FIGURE3. MOUNT THE BATTERY PACK TO A WALL BRACKET'S "U" SHAPE CLIP USING THE SUPPORT BY LIFT HANDLES. REMOVE <br />THE LIFT HANDLES. <br />4. TIGHTEN THE TWO HEX-SOCKET SCREWS ENCLOSED AND REMOVE THE LIFT HANDLES. THE NUTS FOR THESE SCREWS <br />ARE \A/ELDED TO THE BATTERY PACK CHASSIS. TIGHTEN TO A TORQUE OF 5 N.M USING THE M6 TORQUE WRENCH. <br />NOTE: IF MOUNTING IN GARAGE, BATTERY MUST BE MOUNTED AT A LEVEL ABOVE CAR BUMPER TO AVOID ANY POTENTIAL <br />DAMAGE. <br />I <br />t <br />I\ <br />o <br />I, <br />E <br />oFcA! <br />i <br />I <br />I <br />I <br />I <br />I I <br />\ <br />I <br />I <br />I <br />I <br />1.^t - <br />I <br />LI-__.